Square USB 3.0 Car Mount Flush Cable Extension

Good quality cable, the flush-mounted end worked nice and is well secured. Not much else I could ask of it. My head unit tend to be picky about USB cables and no complaints on this one.

So I installed a KENWOOD DDX57S into my 02' Ford Ranger. This stereo had a rear USB female connector on a 12" cord for Android Auto. So I could have it sticking out somewhere loose but that just looks ugly and lets face it, the cable isn't that long anyways.I opted to buy this flush mount extension cable and am so glad I did! I drilled a small rectangle shaped hole in my dash near the radio and fished the cable through the hole and clipped the female end into place. I Then connected the male end to my female connector inside the dash and taped them together so they cant come loose prompting me to remove the radio just to reconnect them. I installed the radio and housing and now I have a clean beautiful professional looking install. This extension cable works great! I cannot speak about the charging capability of this extension cable as my Radio output is only 5v 1a. However the data transfer is excellent as I use this for Android Auto so it uses my phones GPS and I also can mirror my phone on my radio, make and receive calls, texts or put on Pandora or other things. This extension cable makes it all possible while looking professional.

Used this cable to replace a barely working android auto cable. Did the trick and appeara to be working great with no issues! Short term, i recommend this product!

this can fit in tighter places, when the round USB's don't fit. only thing is that it is harder to make a square hole for it to fit right.

I am replacing the very same cable that had q false contact. The USB of this one feels more tight. I hope it lay!

Nicely built with nice thick cables. The clips on the side hold very well

I figured since most cars now are either usb c or usb 3.1. For most charging power that i would be best to have usb 3.1 as an extension for unit to use with replacement radio in car with new kenwood head unit. It has a short USB cable, which i knew would be too short, to use extension cable with it. I figured worst case i would have to Dremel the opening for cable to fit in. I remove an opening in car with old usb 2.0 connection to use with this 3.1 version. Surprised that once i ran cable thru it i only needed to press it in to lock in place plus it fits inward enough and easy to access with smart phone. Since radio uses apple car play and android to use with mapping program, cable keeps up so far and should last since cable never has to be moved within wiring setup in dash. May block off old usb 2.0 port since it never had enough output to even charge old ipod 3 from years ago.

I installed this USB port into the dashboard of my 2012 Chevy Colorado. I replaced the stereo head unit but the USB port was a connection that came out the rear of the new unit and was out on the floor, you needed two hands to connect anything to it, now I can do it with one hand. It does take some patience to make the opening for it in the dash board