Spec-D Tuning SPL-EVO08-ABS Mitsubishi Lancer De ES Gts, Black Vortex Generator Rear Spoiler Shark Fins

Wasn't bad, it will not fit an evo just due to the wideness but i have a 2012 ralliart and it fit decently. It doesnt go from edge to edge on the roof of the car but its not a big enough gap where it looks bad. Comes matte black, and it looks pretty good. If you read the other reviews about buying more 3M double sided tape, i would recommend it as well. The amount of strips on the back would be enough if you don't plan on going over 40mph, and also be sure the roof is clean before you go sticking the tape on there, the 3M is some strong adhesive but if it gets dirt in there it's not going to stick. I also used a heat gun to melt the tape a little to the surface and it worked pretty good. I recommend this if you were like me and want one and don't feel like paying 200$ for one thats an absolute perfect fit, if you're wanting one thats a complete perfect fit and will have 0 problems then i dont recommend this one because it will leave spaces about an inch long on each side.

The spoiler was decent, yeah the tape that it comes with was weak and they supply you with this glue substance almost like super glue but wouldn't trust. Might cause damage to paint of car when trying to remove but I used this spoiler for my 2009 Ralliart and it was about am inch short but fits pretty decent, looks good and got great comments on it. Buy some extra, and stronger double-sided tape though, overall, I think it was worth it.

Word to the wise go by some 3m level 2 tape and add on to the existing tape, I learned this the hard way because I thought it was ok but had to stop in traffic to pick it up out of the road. Edges need some smoothing as well so pick up some fine 600 grit sandpaper to finish it out.All that said it looks great and fits perfect .

kinda has no arch to it, so when installing if you don't lay it down perfectly the first time your screwed but defiantly looks great on my car

got it professionally installed and it started coming off a few months later. rode on the highway and it started rattling like crazy before flying off. NOT SAFE. If you get this I suggest you bolt it on or have a S**t ton of superglue handy. also avoid highways.

Not what thought, it was too big for my Sportback and I had to cut off the edges so it could fit. The worst part is that the adhesive was cheap and wouldn't stick to the car. The edges are so thick that you would need layers of double sided tape to make it touch the car and stick. The center cut for the antenna is way too big! They need to invest more on putting it on an actual car than just guessing and saying it fits... I still haven't installed it yet cause how poorly it was made.

Cuts on the side a little rigid but overall a good look. Installation was also easy, I did it myself.

Buy extra tape especially if you HOON it everywhere!