Dorman 47128 Valve Cover Breather Compatible with Select Jeep Models

I've had these on my Jeep TJ for over a month now. I had no idea how bad the old ones were until I replaced them. They fit perfectly and there are are no leaks. Along with these hoses and the new valves, I have noticed a increase in power and fuel efficiency. They're kind of expensive for a couple of short hoses, but they're hard to find and no one was beating the price on Amazon.

Jeep WJ '02 4.0. fit and installed perfect as described. feels to be made from good quality material and I have no question if it will hold up. Good quality for the price and will purchase again if needed.

It works for saving the OE plastic line and replacing the old rubber. The intake port side fought me a bit, the original setup has the plastic line going quite far into the rubber/intake manifold, the rib in the plastic line was halfway into the rubber on my original line, so I wanted to get it as far in there again, took some lubrication and wiggling but it eventually went in.

Value for the money, cheap Autopartes solución for a fraction of big store price

2004 Cherokee Laredo, old ones were cracked, this worked great.

If you are trying to find the hose replacement for that stubborn rear CCV (PCV) valve line on that 4.0 I6 jeep that you have to break off from replacing the grommet look no further. This is the replacement hose kit for the CCV valve in the rear of the 4.0 I6 jeep motor. The only CCV that comes out will be next to impossible to remove the old hose without it falling apart from age. The smaller hose is for the intake manifold connection to replace as well and I highly advise you do that one as well. The plastic hose fitting that go in between the two be careful not to break those pulling the old hose off. But, this is a fine replacement and is a big saver on cash over the dealer to fix up the rear CCV hose line connection from the intake manifold to the CCV on the crankcase cover for that rear connection to the CCV elbow (its the grey one in the back).

Exact fit fit for 1997 and 2004 Wrangler 4.0. Bought these for my wife's 1997 TJ 4.0 after trying a complete aftermarket tube that didn't even come close to fitting. These were a perfect fit direct replacement with no modifications! Just carefully remove the stock tube, remove the ends from that. Checked my 2004 Wrangler Rubicon and they its exactly the same.

Fits 1997 Jeep Grand Cherokee 4.0 6 cylinder ZJ. Connects the rear PCV valve to the intake manifold. If you are replacing the PCV valve, its a good idea to order this at the same time because the original is probably dry, brittle, and cracked and likely to break when you pull it off.

Good

De buena calidad

Perfect fit and as described.

Used to be a good brand the quality of the rubber they use has gone down you can tell china been cutting Conner's. The rubber will split off the hose after a month on my 97zj your better off using fuel line rubber than paying for this over price poor quality hose.

Todo encajo perfecto ,de buen material lo recomiendo para este tipo de cherokee