FORESTER Carbide Tip Brush Cutter Blade - 9in x 50 Teeth | Fits Most Straight Shaft Trimmers | Conversion Kit Sold Separately

Works extremely well on brush up to 1" dia due to larger diameter trees weigh more and tend to pinch the blade. Simply cutting larger trees with a pole saw or chain saw, you can then trim closer to the ground with this saw. Had to put a 1" washer between the collar and blade as the blade is thinner than the 3 bladed ego brush blade. Highly recommend, cut hundreds of buckthorn with it, just don't be stupid and keep it out of the rocks and dirt.

Good blade, made short work of some thicket at the edge of the yard. Most of these little trees and shrubs were between an inch and a half to 2 inches thick at the base. The blade stayed sharp even after hitting a few rocks and some hidden re-bar. I've only used it fir about 45 minutes total, but it stayed sharp.

After years of using hedge trimmers, the occasional pruning shear and pole saws, using this blade attached to the extension on my powerhead was revolutionary. While, it cuts the little wispy pieces easily just like a hedge trimmer, when you run up against finger sized pieces of wood that would normally jam up the trimmer, it’s like a hot knife through butter. Definitely a little freaky to have a open whirring blade at the end of the extension, and the other hand, I’m pretty confident any reasonably capable adult can avoid a casualty! Strongly recommend.

Not quite as powerful bas I thought it would be. But I would buy again

Many years back, one of the neighbors decided to plant running bamboo behind his house. I wasn't living here at the time so before I bought this house, the bamboo was filling up the back. Not in my yard, but I'm sure it wanted to! There are no homes behind mine, just a big area where sometimes people will walk. I'm sure the neighbor put up the bamboo for privacy, but it got way out of control. Being that I didn't want to put up a fence - because the view is just too great - but the bamboo was getting too out of control, ordered this blade for my weed eater. I've hired people with machetes in the past to thin it out, but tired of that expense. This thing totally cuts through the thickest bamboo easily. I'm a senior female and if I can do this, anyone can. After cutting through the bamboo, I've discovered trees that were trying to grow.... fruit trees! I didn't know they were there. They never had a chance. And now I have the extra benefit of fresh fruit. Love this blade! It's a sturdy hard worker that seems to stay sharp. Just be sure to bolt it on as tight as possible and check to be sure that it stays bolted tight. Mine has, but I wonder if the vibration could loosen it, so far, it's stayed tight.

It is well made and seems to last enough to cut a bunch of small trees (1-1.5 inches thick) growing TOO close to my house. I usually cut all trees closer than 10 feet from septic and constructions and leave there only bushes. Remember to tighten the CCW shaft nuts well. You do NOT want the blade to fly around.

Smokes anything in its way! Used on a stihl fs 110R and it cleaned up everything I put it to

This blade fit my Ryobi Brush Cutter perfectly. It is the correct thickness and can be locked down to cut thru most brush. Thickness is very important as lesser quality blades cannot be locked down and will spin freely unable to cut anything.

que c est une tres bonne qualite de lame je suit tres satisfait de ma marchandise

Works great on goldenrod and small trees.

did not use it yet

Very sharp. Works great on my brush cutter. I will order again

Fit my sthil combi 111r