WARNErifle-Scope-Accessories

Made of nice heavy metal and fit my scope and the gun as they should. I have already taken the CZ 527 out and sighted it in and the rings held without coming loose. I really liked the fit and feel of them.

This set of rings replaced the provided CZ rings for my 527 American 222 Rem. They were a perfect fit . . . even better than the ones provided by CZ. What else can one say . . . they are Warne quality.

These work on my CZ 527 Carbine with a Simmons 44mag scope. There is about 1/8 inch clearance for the bolt handle, which is about the minimum to work the bolt properly. (As an aside, since this is made exclusively for the 527, the 527 bolt really needs a good swift push from directly behind to chamber well- don't finesse it with your fingers wrapped around the bolt handle.) I had to drift out the rear sight for the objective bell to fit. The scope sits a bit high, but the only other option is a different scope or a different bolt handle. I can deal with the slightly higher cheek weld, and in fact it gives better clearance for my bulky ear muffs. The design is a bit unconventional, in that it's split vertically instead of the usual horizontal split. So you have to put one half of each ring on the scope and dovetail, then put on the other two halves. They are on the heavy side. The rear ring also has a stop screw that fits on the rear notch on the 527 dovetail. A bit pricey, but they work with this rifle.

very nice mounts and fit the 527 hornet perfectly

They're holding a large objective scope securely. Hardly any inner ring polishing was required and they fit tight. Very well made product but perhaps a little heavy.

Mounted Leopold to my CZ 527. Very precise fit. Scope dialed in easy. Has held absolute zero though over 500 rounds aleady.

Rings have a very good fit for my scope and seem to sit well on the CZ 527. Once I try to put all 3 together though, I have issues. Everyone is talking about clearance with the bolt handle, but no one is mentioning clearance from the rear iron sight. I have a Crossfire II from Vortex and I cannot mount it due to the rear sight hitting the objective end of the scope. Keep this in mind before purchasing as I am having trouble finding a riser that is dovetail to dovetail and would prefer to not have to go to a gunsmith to have the sight removed.

If you are looking for the 1in universal rings these are them.

Just what was needed on my Brno.