J-B Weld 8297 HighHeat 500 Degree Epoxy Putty-2 Pack

WORKS PERFECT IF DONE CORRECTLY. WORD TO THE WISE WHEN USING 1ST - MAKE SURE YOU HAVE EVERYTHING READY PRIOR TO USING. 2ND - HAVE A PIECE OF SOLID FLEXIBLE WIRE AS WELL AS A PIECE OF METAL FLEXIBLE BENDABLE SCREEN OF SOME SORTS 3RD - PUT THE PUDDY IN YOUR HANDS TO DESIRED AMOUNT AND KNEED UNTIL MIXED TOGETHER THEN PLACE IT WHERE NEEDED PUSHING IT IN REALLY TIGHT AND WELL THEN WRAP YOUR SCREEN AROUND PART BEING REPAIRED, FOLLOWED BY THE FLEXIBLE WIRE, MAKING SURE IT IS REALLY TIGHTLY WRAPPED AROUND IT, FOLLOWED BY A GOOD SOLID AMOUNT OF THE PUDDY BLENED TOGETHER AS SUGGESTED HEREIN THE ABOVE. 4TH - LET IT SIT AND DRY FOR AT LEAST 24 HRS PRIOR TO USING OR MOVING WHATEVER WAS JUST REPAIRED. HOPING THIS HELP! BLESSED BE!

Dose what supposed to do, used for temporary fix on exhaust system, held up until pipe was replaced, no complaints.

Happy with the product

Works good for small leaks if applied properly.

It’s always good to have around for cheap repairs

A word of caution here. The 2 components are in contact with each other so Old stock will be partially cured making it impossible to knead. Packaging of the stuff I received was yellowed from age and exposure to light. I should have returned it immediately. Ripped up my fingers trying to knead it and after all that it didn't stick. Buy stuff like this locally. New stuff may be worth 5 stars, but old stuff is useless.

I used this on a corning glass lid with a ceramic knob that screwed into the lid with a porcelain piece on the underside. Only took a small amount, around the threaded part and a tad bit in the hole of the top knob. I left it to cure for 2 days and cooked my chicken at 400 degrees gas stove. Worked great.

This is a great product from a functional point of view. The only on site problem has to do with cutting the desired putty out of the protective plastic surrounding the putty mix. Cutting the plastic is troublesome and removing the plastic from the putty once cut is troublesome.

This jb weld to repair my generator cylinder head exhaust port gasket area

Sent me the expired product which the epoxy outer Grey portion had become hard. The packing production and expiry details were torn off. Attached picture for the same.

Easy apply and need 24 hours to get hard. My repair job has been done almost 2 weeks. It works for me, but I dont know how long it will last.

1 sur 2 qui était vieux, rigide et difficile à mélanger

Used it to fix my dryer air filter which broke as a nut had come off. Was not sure how it will dry but it became rock solid. No effect of heat on it after drying. Will see how it stands after multiple dryer sessions. Will update.