Behringer 10 String Multi Effect Processor, AmbidextroUS, Silver (Fbq800)

ＪＢＬのワイヤレスのヘッドフォンを使っていますが･･･４Ｋテレビやプレステ５などの音質の低音に満足出来ずに、この製品を購入。 わたしの使い方は、テレビから高めのミニジャック→ＦＢＱ８００へ接続。 そこから、デジタルヘッドＨＩＦＩオーディオフォンアンプへ接続。 で、その出力をＢｌｕｅｔｏｏｔｈトランスミッタでＪＢＬヘッドホンに。 およそ３年以上使っていますが、故障などはありません。 あと、イコライザを使いたい場合は、掲載写真の右下ボタンはオフに。 オンの状態であれば･･･スルーパスです（イコライズされません） それと、音源にもよりますが･･･低音が割れて聴こえる場合はローパスフィルタをオン（左端）をすれば音はこもりません。 写真ではオフ（フィルターカットしてません）。 中高音域に音が集まる傾向での低音！を上げ！迫力する音質を実感できる思います。 良い製品と思います。

Its a nicely design product that fuilfill your music taste. Initially I was in doubt about its sound quality but when tested with my DIY dac cum amplifire it shows its charecteristics. Background noise is absolutely not hearable and sound is clean particularly at 12 db mode. Voice is clear with ample amount of bass charecterictics within. Only negative aspect is light plastic body which is not firm on its base and often get shifted from its position due to audio input/output jack cable rigidity. Also may succeptible to outside interferance due to plastic body that may allow high frequency to pick up by the internal circuits. Go for it, it will serve your purpose.

Very good device. I use it to change the sound of my electric piano towards the monitors (add more brightness and low end, and reduce some sharpness). It works really well for this! It's a virtually noiseless device, save for when you dial up the volume. At 12 o'clock input volume it sends out the signal 100% of volume as it receives it. Past 12 o'clock, it boosts up the signal. So if your output of your device is pretty low, this device will actually boost the overall volume by around 12dB. Additionally, the 9-band EQ can also boost/cut the volumes upto +/- 12dB. The buttons are pretty self-explanatory. It has a 75Hz cutoff, that will protect your speakers in case of some low frequency popping (like cable disconnect, or so). The second one, is one of those buttons that don't make a lot of sense. In/out is actually to turn on or off direct sound. When pushed in, the light is on, and all buttons and eq of this device work. When off, the sound input is directly routed to the output. In my opinion it makes no sense, because if I wanted to have a direct line, I wouldn't have put this device in between the signal cables. In other words, I think by default this led light and button needs to be OFF, and they need to change it to 'DIRECT', instead of 'In/out'. Meaning, the majority of the time, I will be using this device. The LED doesn't need to be on all the time. But anyway... the 'Input output' button allows you to select to see either input or output volume levels on the eq. It allows you to see if the input level is too hot, or the output level is too hot. The 9band eq works well, however, with the volume dialed past 12 o'clock, the device creates some hiss heard in the last two frequencies (especially when they are boosted) (8/16kHz). FBQ, no idea what this does, however all eq slider leds go off when selecting it, and when playing a tone, the frequency matching closest on the EQ slider will light up. This might be helpful for beginners, when trying to get rid of annoying feedback, or too much frequencies in the room. One can use FBQ to see which frequency offends (the led will turn on), and reduce the volume on that slider. Personally, I don't use it. Anyone with 1 year of more of sound engineering, or who is careful about the sound quality and has worked with mixers before, won't need this feat. Another issue with this is that I've found that some of these leds, actually stop working within a year time. So if you ask me, it's a useless feat, that could have been removed so that the overall price of the device would be reduced. In fact, I wonder why Behringer hasn't yet created a bluetooth operated device that can be controlled by a bluetooth phone and app. No control sliders, no buttons save for power, and perhaps 1 to 4 different modes (banks) that can be saved via the phone. This would easily half the price of the device. Anyway, further on the real device review: 6/12dB allows you to select the range of EQ amplification/cut. The EQ sliders from center up to the max will boost the signal by either 6 or 12dB depending on the slider. 6dB is for fine adjusting. 12dB allows you to adjust some signals that are seriously offending to the ear, and reduces them to a more tolerable sound, better fitting the other frequencies in the spectrum. power button back side allows for 2x mono jack, and 2x kinch inputs, as well as the same outputs. Probably the cheapest and best EQ you can buy for the money, Does what an EQ is supposed to do. Great for adjusting sound of music instruments (piano to monitor, guitar to combo, bass to bass rig, acoustic-electric guitar to stage monitor, flute microphone to mixing board,... the possibilities are endless...), home theaters, even changing the overall sound of a PA system right before the signal enters the power amps.

I added this unit to my new set-up after about 2 weeks without it. I am hard of hearing using expensive Seimens hearing aids to overcome 40 db of hearing loss. I wanted to listen without headphones, so some adjustment to the audio profile was needed. I reviewed about 10 different EQ before deciding on this one. I have been using it for over a week at this point, and I am definitely not disappointed. It is easy to use with several technical features that are useful, some beyond the scope of my application. It worked perfectly out of the box. Although the operating instructions are a little sparse, careful reading and experimentation overcomes any deficiency. I would definitely recommend this unit for play-back EQ where good control of the audio profile is required, without breaking the bank.

My setup is: PC > Soundblaster G6 > FBQ800 > Edifier S1000MKII A great equalizer for the money! The difference of tuning with this equalizer is NIGHT and DAY. I can clearly hear more mids as well as highs and enough bass so that they are all heard equally and 1 isn't over powering the other. Its great that this has the FBQ mode where you get to see which frequency is not getting loud enough or is too loud. Music, Movies and even Discord conversations are enhanced through this EQ as the Gain control boosts the volume of the speakers by a huge margin but also makes audio sound far more clear and more NATURAUL. This is a must buy for people who just want to hear a bit clearer in certain areas of the audio frequency. However I do believe buying the higher end EQ from Behringer would be a much better choice as you can control lower frequencies and higher frequencies compared to the FBQ800. Was gonna go all out on the FBQ6200HD but unfortunately couldn't cancel in time before the order was shipped. Glad this FBQ800 is still awesome though and will make me want to buy the other Behringer equalizers later down the line.