Headrest For Classic Herman Miller Aeron Chair H4 for Remastered Graphite

Perfect accessory. Very high quality and feels like Herman Miller made it themselves. Color and material fits perfect with aeron chair. At least for space grey version

If this was a lot cheaper I'd give it 5/5, but given how expensive it is I really cannot justify that rating. It's reasonably comfortable but not super comfortable. The adjustability of it also isn't fantastic and it can shift too easily.

Been using it for a couple of years with my HM Aeron. A must have for Aeron users, very comfortable! Highly recommended!

This is the H4 In Graphite for the "Remastered" Herman Miller Aeron chair. This quality and finish makes it look as if it's a genuine Aeron accessory. Take the time and READ the instruction manual to INSTALL and adjust the headrest AFTER you've adjust the chair to your comfort. (The directions for the chair are on Herman Miller's website.) After adjusting it for my comfort, I tightened the all of the headrest's hardware a 1/4 turn clockwise to hold the settings a little better. EN doesn't recommend this, as they say the factory settings allow for easy adjustments. I agree, but I wanted it tighter than it was. I never thought an Aeron could be improved, but this headrest does it- DEFINITELY worth the $180.00! THE MODIFICATION: I had the same problem that many people had, in that the headrest would not stay adjusted for height, and there's no way to tighten it to keep the headrest from falling. I decided to use 1/4" ID fuel line to solve this. 1 foot of this product cost $2.00 at my local hardware store. This hose is reinforced inside to maintain its shape, which makes it very strong. To lock the headrest in at maximum height, I needed two pieces that were 2 3/8" long. (I cut them from the part of the hose that has no writing.) I then a piece in a vice just tight enough to hold it still while I carefully cut through ONE side of it lengthwise. Use a new blade in a utility knife and SLOWLY make 3 straight cuts, each a little deeper than the last, following the previous cut. You will end up with a sleeve that fits perfectly over the rod. Open the slit wide enough to go around the rod and slip it on. The hose will close up perfectly around the rod. You won't even see the slit. They are very stiff and don't look too obvious. Mine are on a Graphite (Gray) Aeron. If you have a Carbon (Black) chair, they'll blend in even better! Adjust the headrest where you'd like it, measure how much tubing you need ABOVE the bracket, and follow the directions above. See pictures...

Excelente complemento para mi Aeron. La volvió más cómoda de lo que ya era.