Gretess Steinppo Self Adhesive White Board Paper - 17.7inx 78.7in

it is totally different category , nothing to do with white board , it is plastic sticker maybe useful to book covering سيء للغاية لانصدق الوصف مجرد ورق لاصق ولا علاقة له بالمعنى المذكور بالمواصفات لا ادري لماذا لايوجد خيار اقل من نجمة !!

Very light and cheap quality. Diffucult to be installed

very very very bad and very hard to put on the wall and when i tried to remove. the paint go out also quality very bad

it does not erase and leaves marker streaks ...very poor quality. ended up trashing it best to stick with the expensive brands.

كشكل جيد لكن كجودة ضعيف لصقته على جدار و ثاني يوم لقيته على الأرض و ما يتنظف بسهوله من كتابه

looks cheap so i did not use it

I like the size if this white board its magnet friendly and a fun way to remind the family of daily chores and activities.

It was going to come with 4 markers but there was only one. It was a waste of money on this product.

Strong hold. Not understanding why I seen reviews about it not coming with 4 markers. It was a little difficult to get the markers out of the tube. But all 4 were in there. Easy to apply and cut the amount I needed for the refrigerator. With a little bit of water on a paper towel, it wiped right off. The roll gives you allot for your money

I absolutely love this. Was able to make a sale board and had enough to add to my son's bedroom wall as a distraction while I work.

Time being ok.

First, this is dry erase. Don’t use wet markers. Second, this comes with two markers, not 4 listed on this listing. Third, TAKE YOUR TIME WITH APPLICATION! (I THOROUGHLY prepared my surface before application by first getting grease off with dish soap, removing all the dish soap, then rubbing down with alcohol and waiting to dry. Then, working at a 45 degree angle from a parallel top, I pulled the backing out about 2 inches at a time and pressed the white board out from the center towards the outside edge with a credit card. There was a little bit of rippling along the longest edge, but I’m wondering if that is because the adhesive isn’t as strong there. With all the pressing I tried, it never adhered. This took at least 45 minutes all in all and as you can see my application at the end failed because I was getting tired and because the thin vinyl warped when it was pulled back to fix a tired mistake. I didn’t care about this part though cause it was going to be covered as you see in the images. If your whole thing is going to be exposed, maybe consider taking a break half way through so you don’t bitch it with impatience and pulling like I did.) If it starts bubbling in the middle, I’ll take pictures and document for you. The final photo is a first day shot. All in all, this is a GREAT solution to cover a stain on my white fridge and add functionality to my kitchen. Very excited about this! Thanks!