Belden 8723 060100 Cable, Shielded, 22 AWG, Multiconductor, Chrome PVC Jacket, 3.2" H x 1.7" W x 1.8" L

I love this wire. Literally love it. Each pair of wires is surrounded by an exceptionally tough foil or Mylar wrap with a Z-fold, and the foil is better than any other I have worked with in terms of being able to neatly control and shape it. The jacket on the individual conductors is also superlative - none of the typical shredding or tearing found in other products. The conductor - ditto. I've worked with a lot of small gauge wire that has a tendency to break when stripped, and this - doesn't. It's tough! I had to run the output from the line voltage sense and current transformer for a bayite AC 80-260V 100A BYT-VAEM-034 Digital Current Voltage Power Energy Meter Ammeter Voltmeter with Open-close Current Transformer , and the voltage sense and 100A shunt for a bayite DC 6.5-100V 0-100A LCD Display Digital Current Voltage Power Energy Meter Multimeter Ammeter Voltmeter with 100A Current Shunt . I used two runs of approximately 12' each from the sense points to the display panels 9with the 120V circuit inside some 3/8" flex conduit!) and, despite the low signal level and relatively long "runs", these circuits work great, with no apparent "stray-current weirdness" throwing off voltage or power measurements. Did I mention that I love this wire?

Belden is, of course, a quality standard. Using it for interconnecting right and left channel signals within an audio component works quite good with a minimum of harm to the signal. It even makes a halfway decent interconnect.

It is individually two shielded twisted pair wires. Worked fine for our application, was what the seller described, and came on time.

Product is as specified

Great sensor cable, twisted shielded pairs.