Downcut Spiral Flush Trim Bit

I bought this for using on a trim router mounted in a router table. It works great and is sharp. A lot better than a straight cutting bit. Great quality for the price, I would definitely recommend it.

I purchased this but and it broke while using. When I reviewed it they contacted me and asked if I would rather have my money back or another bit. I liked the way it cut so I chose another bit, received it within just a few days. Any product can malfunction or break. Excellent company.

Cuts well but bearing falls off end

Perfect and good material, works great

do not buy these. the top comes off and the bearings fall off. i bought the 2 pack and the first one lasted about 3 minutes. the top comes off where theres supposed to be a set screw to hold them in place. but theres no screw. theres no way to tighten them. the second one i used lasted about 5 seconds before that one came apart and went flying off. i was using them in my handheld router and the one hit me in the shoulder before flying in some random direction. completely messed up my project. do not buy these, not only do they not last, but you will definitely screw up whatever you are working on. unfortunately my return window closed so im out the money i spent on them, but theres a reason they are cheap. guaranteed to fall apart and mess up you work so you are not only out the cost of bits, but the cost of material and time spent on whatever you are working on. total waste of money and time. be forwarned, these are the worst of any bit you can buy or use.

Perfect downcut for use on drywall triming out windows and door openings. Bearings held up really well.

This thing is a beast, cut through hard maple/IPE/Cherry and Walnut 3/4 IN. thick. No burn marks even on very hard woods. Just cut off the bulk of your material prior to cutting templates out with this. This will significantly increase the lifetime of this bit. A steal for the price!

If you've never tried them, seriously, get one now. I've always used flush cut bits. Decades, still used flush cut bits. Until I decided to try one of these. I'll never go back to regular flush cut bits. These are amazing. I've run dozens of passes using these bits, and they still throw perfectly blade shaped chips like slicing a potato. The correct up/down bit will hold your work against the surface if you're using an overarm router or fixed base router. In a word, the right bit, and they're perfect. Only suggestion I can give for outstanding performance is to trim whatever you're working on as close to the final shape as you can. They will cut with full contact like going through a board to cut out a pattern. But, trimmed close they glide through like butter and won't pull away from what you're working with. I bought several of each, and I'll never go back to straight flush cut bits.

I am new to router table work and this bit was recommended, I’ve been using it successfully with acrylic templates to make shaped boards. So far it has cut well on mdf and hardwoods and my results have improved with practice.

Nice and easy cut on my guitar body. Very happy.

Used it for edge jointing, works perfectly.

Already built two houses with a single bit Great for cutting out windows and doors and floor sheet

Burnt out after used twice now amazon return window has closed despite faulty manufacture. Don't waste your money