PEO PET Smooth Build Plate for Bambu Lab X2D X1C X1 X1E P1P P1S P2S A1, PEO PET Spring Steel Sheet Flexible Bed Plate for Bambu Labs X1, X1 Carbon, P1P, P1S, P2S, A1 3D Printer Platform

Initially I had bad adhesion with regular settings when printing petg, I had to increase plate temp setting on initial layer to 85c in my case and then dropped it down to 75c after the 1st layer and my part turned out great.

Opened, unwrapped and went to print. Spaghetti monsters constantly and nothing would adhere. Tried many different settings and nothing worked. EDIT: They reached out and it’s great! Thank you!!

I'm using an X1C and this build plate has given me my first ever print failure. Nothing I do to the print profile or settings will get PLA to stick to the carbon fiber plate, and other filaments are too hot to use on it. The other side works ok even for PLA, but the carbon fiber side is useless, and the carbon fiber design is the only reason I bought this plate. waste of money, time, and filament

I'm not having the adhesion issues that others reported. I just coat the bed in a layer of Bambu Labs liquid glue, and everything has worked out great. Pattern gets applied well to parts and looks really cool. There is one issue that I haven't seen anyone else mention though: The nozzle cleaning tab on the back of the build plate is sharp. Because the plate has to slide into the X1C bed at an angle, the sharp tab scrapes the rubbery coating on the bed. I'll probably end up printing a little TPU cover for it to prevent the scraping.

I tried different filament and none will stick to the base plate. Very disappointed 😞. I contacted the company and they were wonderful to work with . They sent me a new plate and I'm extremely happy with it. Thank you for your fast attention to this matter will be shopping with you again. Tom Zimmerman

Very cool when you can get it to stick. I tried everything. I was using Bambu PETG-HF. I probably spent more money on filament trying to get it to stick than I did on these plates. I found raising the heat helped with adhesion but then I had other issues. It would probably work decently for smaller prints, but you need to make sure the plate is spotless.

I had to adjust my bed temperature slightly for optimal adhesion, but once dialed in it has performed extremely well. Prints release cleanly after cooling and the surface finish looks great on the bottom layers.

Works great. Need to make sure you remove the plastic film. Otherwise you might not get the desired results. And if you are running Bambu turn off the plate recognization settings.

んーバリがありビルドクオリティは低いですが、用途的には十分使えます。値段を考えれば、まぁギリギリ許せる感じ。