Monument 15mm & 22mm Compression Fitting Olive Puller

Absolutely.Excellent! Worked.First time with minimal effort, perfect.

Great olive puller. Always used cutters in the past but didn’t have the access on this occasion and this was a life saver.

I was sceptical at first looking at one of these. But with my latest job o needed one so thought I might give it a go. What a great piece of kit made removing the copper olives ( one of which was crushed) so quick and easy. Would defo recommend anyone needing to remove compression fittings etc to get one of these. Don’t go for cheaper ones you know the saying you get what you pay for!!

Takes a a bit of figuring out when using one for the first time but excellent quality and does the job great. Used it for 22mm and 15mm olives.

excellent product just what I needed job done

I have been using the Rothenberger olive splitter which is a fantastic tool (perfect for pipes 15mm to 28mm), but there are times when the nut is covering the olive necessitating use of either grinder or hacksaw if it is preferred not to replace the section of pipe. This tool takes care of those problems. Very simple to use (much safer than saw or grinder) and small and neat. On the occasion a little more leverage is required I have resorted to removing tommy bar and using a Philips driver (comfier on the hand too). A few 15mm pipes have needed a little widening before fitting tool (compressed with cutting device), but this has been minimal. Mine (supplied by Amazon) is more like the Silverline model in appearance (ribbed) with two flats on both middle and lower bodies of the tool, not the full hex shown. Those flats are needed at times to separate the two parts of the body of the tool or the fitting nut from the tool. A real time saver and, most importantly, no damage to the pipework.

Not very useful ...messed up most times usually when trying to remove olive causing more work overall

If you carry out a significant amount of plumbing work using compression fittings then this is a must have tool. It works a treat for quick and effective removal of olives without damaging the pipework. It may seem expensive for what it is but it does save a considerable amount of time as compared to say hacksawing through the olive (where there is a chance of damaging the pipework and can take a few minutes). With this tool, the olive is off literally within seconds and works in those situations where you cannot use a hacksaw or other method. So, if you only remove olives occasionally then you may find it hard to justify the expense of purchasing one of these. However, if you have to do this often then this tool is invaluable and will pay for itself many times over (both in terms of time/convenience and being able to re-use compression pipe fittings and existing pipework).