NO-OX-ID A-Special- Electrical Contact Grease- Keeps Metals Free of Rust and Corrosion- Part# 10203 by Storm Manufacturing

I have tried this on half my railway. And there was a noticeable difference my loco ran smoothly and on slow speeds .so definitely doing the rest of track

Works Really well on my n gauge layout and good value for money don't need to use alot to work

Great for model railway to stop track from tarnishing

Bought for model railway.... Waste of money, tried once and cleaned off after a few days. Useless for DCC in my experience.

I struggled to find this because everyone seems to be in on it. Great stuff and it does what everyone says it does.

Molto utile

I used this on my model railway layout that is comprised of a mix of old and new track. After ballasting the layout I had lots of issues with stuttering locos and week spots. I'd seen this and was impressed by various American YouTube videos raving about it. So purchased a pot of it and applied it leaving it on for a few days as suggested. I think I might have put a bit too much on as it became very apparent I had a gradient on one side of the layout as the loco was struggling up it due to the grease. So I spent a few hours wiping the grease back off again using a rag! But since then, everything is running well. I'm not sure if it's the grease or just a better current running through the layout (I did replace the cabling and solder it into place) so it's debatable as to whether the grease helped. I like to think it did.