Update VCM Muzzler Harness Disable Kit Replacement Compatible with Hon.da 3.5L V6 Engine with VCM

This vcm muzzler is very good and is work perfect. I will recommend 👌.

I installed this generic "VCM Muzzler" harness on my 2013 Acura RDX to replaced my failed "intelligent" S-VCM device that had worked fine for 6 years. The connectors are not the best quality but they do work. Just make sure you tug to ensure they are fully seated. I set the dip switch to 82 ohms and verified the resistance with a multimeter (across the black wires). I secured the device with a nylon tie to make sure it wasn't resting on the motor). My test drive confirmed it is operational and the temp gauge needle is 1/2 needle-width below the mid-point on the temp gauge (the same position as the previous S-VCM when it was working). I like that it came with extra resistors, so if the internal resistor fails I can replace it. Out of curiosity I looked up the cost of the one-watt resistors that this device uses. They cost 10 cents. So far, this $9 passive VCM override device replaces my previous active "S-VCM" that cost over $100 and is effectively disabling VCM (and avoiding the attendant issues). If it fails I will follow up.

It stopped the ECO signal on the dashboard and the vibration when driving, for my 09 Honda Pilot it worked with 82 ohm

Installed in my 2012 Honda Odyssey, check engine light stayed on and vehicle ran poorly. Removed and spent a little more for a better part

it works stoped the plugs fouling and oil consumption