Genuine Henke Loctite 609 X 50ml Retaining Compound, General Purpose, Green Color

As described, worked great

Worked as stated! Do your research Loctite have several similar products and one of those might work better?

Great glue!

Want it to stay in place? Use this. You will Need a torch, if you ever need to remove a bolt

I do wish they had smaller bottles. Needed this for a one time use thing. By the time I'll need it again, it will be expired. But otherwise, it worked securing a bearing onto it's shaft!

The gear on my Sherline threading attachment stripped out the press fit on the shaft somehow. I put this stuff on the joint, put it in a food dehydrator for a day or two to cure it faster with the low heat (some technical document I found about this stuff indicated it might take an entire week to reach full strength on aluminum otherwise), and presto my gear is stuck to the shaft. Haven't pushed this stuff to the point of failure, but it did hold up to a decent bit of cranking torque from my hand, with less than .001" clearance between steel shaft and aluminum hole. Who needs press fit tolerances when you can make slip fit tolerances and glue it together?f

👌💯👍

Used this to install a pressfit bb30 adapter to shimano 24 that was creaking. After a few months its been sounds free. Worth every penny.