Auto Window Seal Weather Stripping, 4PCS Window Moulding Trim Seal Belt Weather Strip for Honda Accord 2008-2012, 4-Door Sedan,Replaces#72410-TA0-A01 72450-TA0-A01 72910-TA0-A01 72950-TA0-A01

First off they came on time and the packaging came very snug and secure to keep from damaging during travel. I have a 2010 Honda Accord ex-l v6 and they fit perfect. The back windows probably took 5 minutes to line up and snap on the only part that took so long was the pieces already on my car was old and was very hard to get off. Now the front windows at first was a struggle because I thought I had to take off my mirror but decided not to because I could not get one screw off without removing the door panel. Some people can reach it but for me I couldn’t with my tool. So with some force I slid the old one back and from under my mirror without taking the mirror off. And installed the new piece the same way. I slid it under the mirror and snapped the clips with no problem. They are so much more affordable than the dealership and they look exactly the same. Once these are ready to be replaced I will be ordering again

Shipped in protective packaging and arrived undamaged. Quality is at least as good as the original window stripping (Honda OEM). Chrome covered with protective film and holes for screws lining up perfectly. Plastic clips make for an easy installation. I was reading one review suggesting to slightly bend the window stripping for the rear window. However, I would advise not to do this as it is not necessary. The window stripping will naturally bend when screws at both ends are gradually tightened. The original window stripping for the rear windows sprung back to being straight when I removed them from my car. I will follow up on this review once I can say something about durability.

I am very pleased with the product.

Bought these for my 2010 Accord. Front windows fit well and an easy install. My issues are with the back windows. While the install was equally easy as the front, they don't fit as well as OEM parts. There is a slight bend in the window frame that isn't easy to duplicate with these replacement parts, and caused the replacement parts to not fit well at all. There was a significant gap towards the back between the window and the new part. I complained to the manufacturer and to their credit, they sent me new ones, at no cost to me, to try to remedy the issue. Unfortunately it didn't. I installed the first new replacement from back to front to see if that made any difference, and it did, but only slightly from the first parts. Then I realized that by SLOWLY and very GRADUALLY bending the part over my thigh could I affect an approximation of the proper bend to fit the window frame. There's still a gap, but not as big as before. If you try this be very careful. It's thin metal and bends VERY easily. Also, a trick I devised for replacing the front moldings so I didn't lose the front 8mm nut holding on the mirror; if you lose it you're sunk. What I did was apply some contact cement to one end of a piece of string, then tie the other end to something so the nut wouldn't disappear into the door and be lost forever. Then I applied contact cement to the flat side of the 8mm nut, let the glue dry on both dry per manufacturer's instructions, then joined the two parts together. Then if during assembly the nut dropped off the bolt holding the mirror, the nut wasn't going down the door, and I had another shot at attaching it. Once the bolt was on, I just pulled the string off.

These are not quite an exact fit for my 2011 Honda Accord, the front two are perfect, however the rear two do not quite fit the contour of rear pillar of the window. Also, the packaging needs to be better, as both of the front sections on the front pieces were broken in shipping, thankfully I was able to use the originals from the ones i removed. Overall, the look and quality of this kit is excellent.