• Training Gear Set: BCX/2/3.

Tech Note * NOT for use with Flybarless Helicopters * Carbon rods approximately 0.085 inch in diameter, 8 inch long Detailed Information Locate the four training gear rod to landing skid attachments and four screws. Note that there are two each of two types of attachments. Carefully snap two of the attachments to the landing skids forward of the landing skid struts. The side of the attachment with the large hole should face outward, away from the helicopter, and forward to the front of the helicopter. Next, carefully snap the remaining two attachments to the landing skids behind the landing skid struts. The side of the attachment with the large hole should face outward, away from the helicopter, and backward to the rear of the helicopter.Once you have installed all four attachments, install the four screws making sure that they thread properly into the back side of the attachment. It may be helpful to squeeze the attachment with a pair of pliers to make it easier to thread the screw into the backside of the attachment. Do not tighten the screws all the way at this time as the attachments will need to be adjusted for proper alignment once the training gear rods are installed. Locate the four training gear rods and rod ing base. Note that the rod ing base has four channels into which the training gear rods will . The open side of these channels will face upward toward the bottom of the helicopter when properly installed. Carefully pass each of the rods through the attachments on the landing skids and into the channels on the base. Take care to not pull the landing skids out of their s in the battery supports. After ensuring that the rods are secure in the base, adjust the positions of the attachments on the landing skids so that the base is centered under the main shaft of the helicopter