Eddy+ Replacement Cap & Straw

Fits a Nalgene bottle perfectly! Completely water-tight seal, easy to clean, good quality materials that seem as durable as the Nalgene it's on. Would buy again with no hesitation, but this feels like a lifetime purchase.

Perfect fit! The straw was a little long but I just cut off the end with some scissors and it works like a charm!

Came as advertised . Perfect fit. Seems more sturdy than the one it replaced.

Why did you pick this product vs others?:Already had a camelback water bottle but no top, so wanted a top & straw to fit it. Sticking with the same brand seemed most likely to fit properly, not leak, & be of good quality. And indeed it was all those things & I now use the water bottle every day.

I wanted a bite valve lid for my Summit bottle by Simple Modern and went on the hunt for one that might fit since SM doesn't make one. This lid turned out to be almost perfect. It's a bit of a tight fit to screw on and may eventually strip the lid inside, but once it's on it doesn't leak and has worked great for daily use over 4 weeks so far. I haven't had any issues with the opening the in the bite valve being sealed or leaking anywhere like some reviews state, however I don't pack my bottle in a bag or lay it on its side ever so it still may not be watertight.If you plan to use it with a Simple Modern bottle, just know the straw length is a bit too short for the taller bottles (22oz, 40oz, 84 oz) so I have about 2 inches of water left in the bottle once the straw no longer reaches and I need to refill. I looked into just getting Camelbak Eddy+ bottle, but they don't offer nearly as many patterns and colors as other brands like SM. I also see that they offer a longer straw for the old version of the Eddy that would solve the length issue with mine, but I don't think those straws fit these lids.Bottom line: If you're looking for a good bite valve lid for a standard flask bottle of another brand with a 2.25 mouth opening, I highly recommend trying this one. I can't speak to the leakproof qualities, but the bite valve has worked without issue for me.

I have three old Camelbak Eddy's from like 2013-2016. They've worked well and have held up, but there is mold under the straw valve area that I cannot clean out. The housing unit where this is underneath the lid is not easy to access to remove that little valve/nozzle to properly clean it. Since the Eddy's are no longer made and I didn't want to get rid of perfectly good water bottles I decided to take a chance and purchase the Eddy+ lid to see if it would fit. Other reviewers said it did and it does, perfectly! For both my 600ml and my 750ml Eddy. I just put it on my water bottle last night to use and have no issues. When I hold it upside down it doesn't leak and when I held it upside down on an angle it didn't leak (picture shown of this with my 600ml Eddy). I'm hopeful that the little nozzle area on the Eddy+ will be easier to clean should mold start to form. I've attached pictures of the old lid which i slight gray and the new lid which is black to show the comparison of the little nozzle thing I'm talking about.One thing to note is that the straw that comes with this is long, too long for my 750ml, but they're easy to cut. The design of the straw opening is slightly different (wider hole) than the previous Eddy, but the old straw does still fit and it's what I'm using this morning.

I have an old 3/4 liter Camelbak Eddy water bottle but no top. This replacement cap fits the water bottle well. I trimmed the straw a little to fit in my bottle. The mouthpiece is easier to take off and clean than the original.

Fits well