LLPT Butyl Tape Black 1 Inch x 33Ft Tight Seal for Leak Proof EPDM RV Repair Window Glass Boat Sealing Roof Pipe Patching(BST233)

Good quality tape used for sealing. I used them putting up corrugated pvc sheeting. Exactly what I needed. Good bonding on wood, metal, and pvc, even in a drizzle. No leaks where it was applied. I can recommend this, if your in the need for rubber butyl tape that works well and is easy to apply.

I purchased this 1" Butly Black Tape to create a waterproof seal between the hardware used to mount a Slide Topper to an RV slide. This is some very stick stuff, even in 70 degree weather. It worked great. I applied it to the back of the hardware and carefully stuck it to the mounting spot on the RV. You definately do not need to worry about the part moving while you are screwing it down. A putty knife helped remove the excess that squeezed out on the edges. Followed up with 100% silicone aroung the edges and there you go. I can't imagine any water infiltration would get behind the hardware. I liked that it came packaged in it's own box. I didn't have to mess with crushed or squished tape. The box will definately help store it securely until it's next use.

I've used good butyl tape in the past for sealing above the waterline deck penetrations in boats. And I've refused to use bad butyl tapes...as they are just not worth the effort to use and often make a big mess. I needed some butyl tape to install a replacement RV roof vent fan and my usual go-to stuff was unavailable, so I decided to give this one a try. I can say this appears to be quality stuff. The roll came shipped in a cardboard box so it wasn't a crushed mess like some others you can order. The initial feel was virtually identical to the stuff I usually use. It is a bit sticky/tacky, but not overly so and pliable, but not overly soft. I squeezed a small piece between my finger and thumb for a minute, then pulled them apart and it did stick and stretched quite nicely...indicating it should provide a good seal at normal temperatures. I ran a couple tests with two small pieces to check how it dealt with temperature changes. One piece was mashed between a folded piece of cling wrap and placed in the freezer (-2F) and another was placed between a folded piece of parchment paper and placed in my toaster oven on warm (160~180F). After 20 minutes in the toaster, I removed the parchment paper and peeled the paper apart. The butyl was just a bit softer than room temperature but it didn't flow/melt and still had good structure. It adhered to the parchment paper and stretched like it should. I (accidentally) left the piece in the freezer for over a day. When I took that one out and tried peeling the cling wrap apart, the butyl again stayed stuck to the film and stretched quite well. This is exactly how a good butyl tape should be...remain pliable and a bit sticky for the whole expected temperature range. The only thing I can't judge right now is if this will remain flexible over time, but it seems like it should. If it does, it will make a very nice and permanent seal. I had no hesitation about using it for my RV fan install project. I will update this review if I find an issue down the road, but I do not expect one at this point. For those that have never used butyl tape, here are a couple hints. Butyl tape is not an adhesive, it is a sealant and requires another means of structural attachment (usually screws). For a good, water-tight seal, apply the tape to the object, then tighten the mechanical fastener (screws) until snug and the butyl is squeezed just a bit. Then let it sit a bit so the butyl flows (ok, not flow but slowly squeezes) and stabilizes. Then go back and tighten a bit more. Repeat this process until the items is secured. You can then use a plastic putty knife to trim away the excess. You can also use a ball of the sealant pressed/tapped against the oozed out sealant to clean up the seams. Just don't pull at it. If you keep the ball of removed sealant clean, you can even reuse it for another project. I recommend warmer temperatures if possible, as it makes this process go more quickly. If done properly, butyl will make a very good, long lasting flexible seal. So, my initial impression is this is a good quality butyl tape and is highly recommended.

Not as sticky as other butyl tapes I have used. I like the color as it looks great with my white camper. Very easy to use and versitile, as it serves numerous functions. It should keep out most leaks, but I had to heat it up with a heat gun to get it to seal.

Great stuff. Works well. Tip: fold into half (like a rope) to apply on uneven surfaces.

Good work and good It adheres to the surface.

Redid all windows doors trimming on my 30' skyline weekender89" I bought from 2 other suppliers and this beat s them both hands down cheaper and fresh Easy to work with and the wax paper stays on until you peal it off A big factor when replacing it on aluminum framing I got both black and white and wish I just got black all the way around some windows needed thicker do to the framing that was tricky sticky using this stuff assures the weather will be kept out now No instructions Its shipping box is a great protection abd stores to be undamaged Fast shipping for the white took 2 extra days for the black to arrive I will only buy from this seller for this √√ If your comparing Don't buy from RecPro the worst and a waste of time and money its their product is Old smashed rolls suck togetger and wax paper didnt stay on causing alot tobbe wasted very hard to work with and hard to return crappy supplier

Good butyl tape well worth it

La he utilizado para sellar la claraboya Seitz grande de techo en mi AC y estoy muy contento con el resultado. No escatimes en cantidad al montar. No vuelvo a usar polímero para sellado nunca más, ya me ha fallado varias veces con filtraciones. Mucho más seguro el butilo.

Did exactly what I needed it for.

Muito bom material , bastante maleável excelente para aplicar

Habe das Band zum Eindichten einer Dachluke, sowie mehrerer Lüftungsgitter am Wohnwagen benutzt. Lässt sich sehr einfach und gut verarbeiten. Es ist alles dicht. Das Produkt bleibt elastisch und härtet nicht aus! Damit ist es perfekt geeignet um vibrierende Bauteile oder welche mit starker Wärme- Kälte-Ausdehnung abzudichten.

Great stuff. There is a bit of a learning curve to using it effectively. Free tip, keep everything clean. Another free tip, watch a couple of youtube videos before diving in to leakproof your deadlights. My deadlights don't leak anymore but, had I informed myself better, they would not look as tatty. They still look much better than when I tried it with Sikaflex. Update: Don't use this where it is exposed. It will still be waterproof but look terrible as it remains sticky, forever. I now use this for bedding and waterproofing but seal off with with Sikaflex 591. Another tip, Use White Spirit to clean it off places you can't work out how it got on to.