Daystar KU31002 5.5 Inch Heavy Duty 5.5" Jack Pad

This spacer works perfectly to add some height to my floor jack. I can get my Jeep high enough to remove the wheels. Very well built and the groove fits into the body work so no slipping.

It's a solid piece of rubber that won't deform under load. It does come with a light oil coating on it so be sure to wipe it down with a mild solvent (rubbing alcohol, mineral spirits, etc ) The base is indented so make sure it will fit over your floor jacks saddle before buying. Ultimately I returned it tho because I just felt a piece of 4x4 serves the same purpose at a fraction of the cost with a minimal loss in achievable height.

This jack pad works fine. I took it out of the box and put it on my floor jack, and raised my car up enough to get a couple more notches out of the jack stands. Makes muffler work a lot easier to have that extra couple inches. I had no issues with it slipping or even moving around once it loaded up.

Bought this to add more height to my sliver and blue Harbor freight floor jack, it's a bit bigger the the jack portion but once centered and weight added to it seems to work really well and get my truck higher up to work on, works as it should but not perfect

Very slippery. I used some milk mineral spirits to get slick off. but grips well on my new low profile jack

Well, is much better than a 2x4. But it does cost a lot more! It is very grease and slippy when I receive! I wash off all the grease before use, otherwise just like other say, is very slippy! Does it work, yes. My rag is about 4500lb, It actually does not have full 5.5" additional lift. I will say about 4.75" max. But again is better and safer than use wood.

I like it works very well gives you that just a little extra height

works wonderfool, made of a good quality rubber that holds up while being used. I've used it with my Chevrolet Silverado truck and it works great.

Very useful and perfect fit.