Geekria Mesh Fabric Headband Pad Compatible with Sennheiser HD600, HD580, HD650, HD660S Headphones, Replacement Band, Headset Head Top Cushion Cover Repair Part (Black)

It fit perfectly and installation was easy once I found that the bracket at the end needed to be removed. Instructions indicating so would have been nice.

Very nice/comfortable replacement headband for my HD6xx. Fits perfectly.

It was a little stiff the first few times I used it, so it caused some discomfort, but it just needed some time to loosen up. Good value too.

Easy to install and a fit price. For both my vintage HD580 and 58X Jubilee.

I used this product for my Sennheiser HD280 Pros. I They were not specifically designed for this set of headphones, but I used some velco tape to attached a strip to the headphones where the pads go, then added the other side of the velcro tape to the underside of the pads themselves, then velcro'd the pad to the headphones. I had to do a little measuring and trimming but mission accomplished and it looks like it was always meant to be. Comfortable pads that do what they are designed to do. This is not a complicated product.

I've been using my first high-fidelity HD600 headphones for years, which have always been exceptionally comfortable and lightweight. However, over the past year, I noticed that the headband's padding has significantly degraded. When looking for replacements, I had three main options: a budget Amazon knockoff from Geekria priced between $10-$15, an official Sennheiser replacement for the HD650+ style compatible with all HD5xx and 6xx models priced at $25, and a $15 option from Dekoni available on their website. I first tried the Geekria knockoffs, which were terribly uncomfortable—almost like styrofoam, causing migraine-level discomfort. This discomfort was especially noticeable since I haven’t adjusted the headband since my initial fitting back in 2006. I couldn’t get the Dekoni headband since it was on backorder, but I have previously used their leather earcups and found them to be of good quality. Ultimately, I ordered the official Sennheiser replacements from Amazon, which featured true memory foam and greatly restored the original comfort of my headphones, although it's a slightly different design from the original HD600s. My conclusion: it’s worth spending an extra $10 for the genuine Sennheiser replacement to ensure comfort. The Geekria version felt substandard, possibly due to poor quality control or just a difference in materials that some users might not recognize if their original headbands had been worn down for years.

Easy install and fits perfectly with my Sennheiser 6XX, but the comfort level is not great. The foam is too firm and is very different from the original. After wearing a while it can get painful. Unfortunately I will probably have to buy something else.

This works great for my Sennheiser HD580 headphones that I bought way back in 2000. The original headband was toast (completely flat) for a very long time. As far as I can tell, this is the same as the original headband pad, although I have not done a side-by-side comparison of a new pad from Sennheiser with this one to be sure. For my purposes, it works fine and I don’t really care if it’s *exactly* the same. We will see how it lasts over time since I just did the replacement. It’s nice to have some padding there again! This pad does not come with instructions for how to perform the replacement, but it didn’t take much to figure it out. Replacement can be done in a few minutes. Remove the plastic tab on one end of the headband arch by pulling the tab inward radially (toward the middle of your head if you were wearing the headphones). I was able to do this with my fingernails, no tools required. Maybe with newer headphones a needle nose pliers or flathead screwdriver might be helpful if your fingers won’t do the job? Slide out/off the old headband pad and discard. Notice there will be two separate tracks on the headband arch. The outer track is for the sliding fitting mechanism for the earphones so you can customize them for your head size. The inner track is for the headband pad. Slide in the new pad on the now-empty inner track. Replace the plastic tab from where it was removed. Done.

Ist bequem, passt, was will man mehr?

The replacement part fits my headphones perfectly. Arrived in a very timely way, and for a competitive price.

Past goed en zit goed.

Works fine. Fits fine. Maybe a little more solid than the originals but that is actually an improvement because the originals were too soft and deteriorate in no time.

ほかのヘッドホンにつけて使ってますが、音が全然変わります。 頭の安定具合は、低音に影響が大きいようです。 頭頂部が安定すると魅力的な低音を出すようになります。 でも一つ気づいちゃって……。 パッドでこんなに音が変わるんだったら、モニター用途ではパッド無い方がいいな…って、あーだから…モニターヘッドホンにはパッドがないのか…