Atlas Epoxy 14 OZ Set (White)

Worked great for sealing my pool light cable. Sets fast

Make sure to use cloves

Worked perfectly for intex big swimming pool. All benefits as described.

didn't test it under water

Far easier to spread on a wet surface with wet gloved finger than dry. Handled with wet gloves it is as workable and easy to spread/push into cracks with a finger as clay or auto body filler, almost impossible to get it to stick to dry concrete and will not likely bond well either.

Todo llego ok. Muy buen producto.

This stuff is fantastic! I help to maintain the community pool for our condominium association, which is an oval pool with fiberglass sides and a plaster bottom. The caulk between each of the fiberglass panels had deteriorated and we were losing significant amounts of water through the seams. We considered draining the pool to re-caulk the seams prior to opening, but with the heavy storms and flooding in our area, we were afraid that hydrostatic pressure could do further damage to the pool. After quite a bit of research I found this product and it seemed like the perfect answer. I cut the compound, including the cardboard tube, in sections about 1 inch long from each tube and mixed/kneaded the two materials per the instructions. I then rolled the product into strings about the thickness of a cigarette and applied them to the seams, both underwater and above water. When I ran out of material, I mixed more, doing it in this fashion to ensure that the product didn't begin to harden before application. Application was simple, and it was easy to smooth the material into place and ensure a tight seal with just my finger. I sealed all 10 seams with one set of the product. I checked the seams after an hour, and every seam still looked perfect and the product was literally as hard as a rock. Time will tell if the product holds up as promised, but I see no reason why it should not. Using this product was actually far easier and less expensive than using Vulkem Seal or a traditional caulking product, and was easier and neater to apply. I also expect it won't deteriorate like other sealants. Based upon my experience so far, I would definitely recommend this to anyone requiring a sealant for similar purposes. I also intend to make this product known to my local pool supply company to recommend to others with similar issues.

Worked well! I purchased this because I needed to replace a weir door and that mean destroying the seal between the pool tile and the skimmer. This was easy to mix and apply and began to harden in a couple of hours. My only issue was that it did make the surrounding water cloudy during the application. So you'll need to stop, run the pump for a few seconds, and then continue. I've never used an underwater putty so that could be a common thing between all of them, but it's noteable. But I can't argue with the results. It looks good and I haven't noticed the water line dropping more than usual so I'm assuming it's holding water just fine.

We have a cement pool & knew we had a leak somewhere. We had an idea where the leak was and we used this product under the water to fix the leak and it worked great. It doesn’t take long at all for it to work! We haven’t had any issues all summer so we will see how it look next summer.