Tondiamo Rubber Stamp Sheet for Laser Engraving Machine, A4 Laser Rubber Stamp Sheet for Cutter Soft Stamps Making DIY Art Design(Light Gray,1 Pack)

Worked great on a 40W Epilog Fusion Edge laser engraver. Smell was minimal. Not sticky & very crisp design. Perfect thickness.

Made my first rubber stamp with a 22W diode laser. Nailed it on the first try. This material engraved perfectly with minimal residue / ash. Easy cleanup with a brush. The durometer seems just about right for a rubber stamp

Works great in my laser. The real trick is to make sure you are set to use ramping when carving a stamp. Without the ramping the edges don't cut cleanly, which is counterintuitive, but it works. Settings will, of course, be different for different machines, and multiple passes reduces burn, but if you have a laser engraver you should already know this. All I can say is that even my 10w diode laser was more than powerful enough to make nice stamps. Be sure to add a wood backing, as the thin material is too floppy to use without a solid backing.

I had a project that required a rubber stamp so I gave this on a try. The material is very pliable yet retains intricate details easily! I use a 40-Watt diode laser and found a setting of 70% power at 700mm/min perfect. There isn't a lot of smoke but there is a lot of particles ejected during the burn (be ready to dust!). I found that with multiple passed I could cut the finished stamp out of the sheet. Be aware if you do this, the material tends to cause "soot" in the cut which blocks the laser from easily reaching the bottom (even with air assist on full). Overall, I'm very pleased with the quality and the value. I will be back for more soon!

I had been looking into having a custom stamp made but prices were too high for my budget. Came across this material that another laser owner was using and making videos with so I decided to give it a try. This is THE product you want if you own an F1 and want to make your own rubber stamps! There was a bit of trial and error to dial in proper settings but once that was done, it works perfectly! My photo may look scary with the flame but it is merely a flash of flame while the little bits getting engraved burn off. There was no actual fire or melting with this product. I did not understand the clear message on product bag stating "This is a set, do not separate" unless I got shorted something in my order. I received one sheet of rubber stamp material. Love this product, will buy more as my need for custom made stamps increases! (Remember to mirror your text while designing your stamp!)

This rubber is quite hard / firm. I made a large (3”x3”) stamp with it, and when using the stamp I only get ~90% of the image unless I really press hard and rock it back and forth. This means the stamp isn’t really useful for me. If the rubber was a little softer / more forgiving it would be better. It’s possible this is my fault in the stamp design, though.

Excellent, will buy again

My first time making a rubber stamp with the Glowforge Aura. This rubber cuts smooth & delicate details are not lost. These stamps I made was only 1" in diameter. There is a lot of dust that need to be cleaned up & mini vac is highly suggested. Amazon says the material is .09, but my caliper says .08. So you may need to test yours. The settings I used were: Unknown Material: .08 Engrave: 100 / 10 / x4 Cut: 100 /10 / x10 Twice The cutting is where it got tricky. 10 passes, the limit on the Aura, is not enough to get through the rubber all the way. What I did was do a first Cut & Engrave session, then I changed the engrave layer to ignore so that the only thing left was the cut layer & hit “Print” again. Even this was not enough to go thru the rubber completely. However, It was so close that I was able to “pop” out the stamps. You could probably do a third round if you want.