D210CON Diamond Blade Continuous Rim For Mitre Saws, For Cutting Reinforced Concrete, Stone, Brick, Tile, Porcelain & More, 25.4mm Bore, 210mm, Black

In the process of building a piza oven, I attempted to cut the very hard and tough firebricks with the tried and tested hammer and chisel technique, which was an utter disaster - rough edges, broken bricks etc. Firebricks are way too hard for the traditional approach AND a seamless neat finish. I didn't want to waste another firebrick (they are £1.70 each!), so I started looking to see what I could find to work with my current power saws. Bought the evolution diamond disk (to match my Evolution mitre saw) and the results have been superb. Absolutely beautifully straight smooth edges and the ability to custom cut the fire bricks to any customised shape, angle etc. This is really important when you are building a curved oven! I would hazard to guess that this cutting disk is not recommended for firebricks, because they are so hard and dense, but so far, it has done the job admirably... I am halfway through and the disk shows no signs of bluntness or reduced cutting ability. I have also used a tip I found online, and that is to soak your firebricks in water for 90 seconds before cutting them. This both keeps dust levels low and lubricates and cools the blade at the same time. My only grip is that, because this is a 210mm blade and not the usual 255mm on my Evolution Rage, that it doesn't completely cut the bricks through, but leaves maybe 8mm uncut at the bottom because it can't drop far down enough. I knew this going into the purchase though and in any event, it's really easy to snap the bricks once the bulk of the cut is done and neatening up that small edge is really easy - or you can flip it over in your mitre saw and neaten it up with the disk again if you really want a neat finish.

Excellent product ❤️

I think my evolution is great and when I had to lay some huge tiles in the hall and some slate tiles in the fireplace I decided to give this a punt. In the past I had used one of those little water-cooled wheels you buy specifically for ceramic tiles. This would not have been able to bevel the slate tiles the way I wanted to, and also I just knew it would take forever. Anyway, the Evolution plus this diamond blade just chewed at the tiles I think it's great. Lots of dust and noise, but its worth it. I found that the wheel lasted quite a long time but perhapst because it is not water cooled it was starting to lose its edge- so I've bought another.Forty quid overall for all that cutting is not bad for what its done and the time its saved.

A diamond geezer that cuts.

I had some old roof tiles that I wanted to cut for a home-made tool store. They were quite wide so I had to use a plunge cut to get started but this blade did a great job and all edges were smooth with no chips. Fitting to my Evolution chop saw was very easy just not sure why manufacturers put the direction of travel on the blade using ink because it rubs off after the first cut.

Great blade it dose everythinf

We are block paving a drive which is not square. Several cuts would be needed so I purchased this blade to use with my Evolution 210mm chop saw. It’s easy to cut and you can safely hold a pavior as the blade has no teeth so it doesn’t snatch like a toothed blade can do with timber.. The cuts are clean and precise but you can also trim a block if it’s tight and you need to take off a gnat’s cock to make it fit. Highly recommended

Found these diamond cutters, these seem to be an odd size so cannot be purchased anywhere else for the evolution machines. Thought being the genuine article it would have a good life especially as they are not cheap. Performed brilliantly when new but after cutting block paving bricks after about 20 cuts there was a noticable reduction in performance. I laid about 9 square meters of bricks and had to purchase 3 blades to complete the job. Wouldnt really rate these after this experience.

Coupe parfaitement le travertin et dure dans le temps

Ottimo disco per tagliare mattoni ceramiche provato da poco consigliatissimo

Perfecto para cortar azulejos. Antes usaba un cortador manual pero al comprar una ingletadora para madera aproveché para comprar este producto y no me arrepiento.

Lama diamantata taglia in maniera veloce precisa e pulita

super easy to saw thick tiles