3M Spray90 High Strength Adhesive, 500 ml

Worked well on a headliner. Slightly difficult to use on your own as it grabs instantly.

I purchased this to re attach the glass that fell off my wing mirror on my Audi S5. After reading an online article on how to remove the heated back plate from the mirror assembly I cleaned both the plastic back plate and rear of the glass and used the adhesive as recommended. Remember this is contact adhesive so it needs to partially dry for a few minutes prior to mating the two parts together. For those removing heated back plated that the glass was attached to, be careful removing the spade connectors from the heater pad as being too rough can damage the heater pad itself. This is a fantastic adhesive and allows for thermal expansion differences between the plastic heated back plate and the glass. Do not use super glue or epoxy type adhesives as these do not allow for the difference in expansion between glass and plastic. This is a top product and has so many uses around the home and for DIY. It dries quickly and forms a very strong bond.

Easy to apply and sticks really well But be aware its instant contact so make sure the parts are aligned before placing them together

Good product but to expensive.

Used it for a car headliner, it was okay, the spray was sometimes intermittent.

Only used this once so far but it did the job marvellously, sticking the glass of a wing mirror to the backing heater element.

Not as good as other reviews have suggested. Used outdoor for joining 2mm rubber sheets. Slight wind caused the 5" overlap to separate. Canister didn't last that long. Expensive for the results.

Rly good for my cars headliner