Ring Rainbow RGB Fans

Great little fans. The only reason I bought these is because the motherboard I was building with didn’t have ARGB support, so I needed the remote. That said, the hub does include a 4-pin fan header, so you can still control fan speeds through the motherboard—just not the ARGB lighting. It also has ARGB connections available if your setup supports it. I also prefer having a separate ARGB/fan hub with traditional hookups—one for fan control and one for ARGB—but that’s just me being picky about how I set things up. These fans are pretty quiet overall. They do get a bit noisy when ramping up, but I’d still put them in the reasonable noise category. If you’re gaming, they’re going to ramp up anyway, and they’re no louder than a GPU under full load. Everyone’s use case is different, but personally I wouldn’t buy these for my own build. This set was mainly for a computer I’m putting together to sell.

great fans, install very easy, recommend

Cute and serve their purpose, however after a while I started feeling that they looked a bit cheapy compared to other PC fans due to the individual LED clusters. That’s just my personal opinion though because I know for others, it gives the fans their charm. They produce no noise, airflow is good, and it pushes the warm air out. I do have issues with the remote situation, I’ve noticed that other controllers to other LED devices will intercept any commands and the fans will change as well. For example, my boyfriend has an LED strip under his desk and when he changes his colors or mode w his remote, my fan colors will change. The same thing happens when he uses his other remote for his PC fans. I had to buy a separate fan hub at one point due to the pins on the connectors being incompatible with the ports on the mobo, which is something that I didn’t see too much of on in the listing so I wasn’t able to compare. Aside from that though, they’re definitely a good budget set of fans until you’re ready to upgrade. Lots of different modes with different colors!

My sons Montech 903 case has room for 9 fans and came with 4 already but only the front 3 lit up. Bought this 6 pack to put 3 on the top facing out, 2 on the bottom above the PSU facing up, then replace the backwards exit fan that didn't light up with the case it came with. These look awesome, easy to run to the control box and then takes 1 cable off the psu and turns on immediately with the computer power up. The fan controller lets you reduce the speed of the fans which is great, so they can be reduced to make less noise if needed as I've seen some fans out there on sale if nor controlled by the motherboard you can't adjust the speed. All fans fit and look like high quality units!

Came with bolts and everything, the remotes a bit tricky sometimes as shown on video but overall it works well and it kept the whole case cool since I have i switched to an Air cooler instead of my AIO this does the job well, its quiet too and it came with a little double sided foam type tape for the fan hub to stick on the back of the case.

I installed these in a new build and I cannot get the fan error from showing up at boot. Also, one of the fans is defective and is only glowing at like 10% compared to the rest of them. My motherboard is a 3-pin board. When I connect the fan using the guides on the wire connector, the error message appears at boot. Once the error message is bypassed, lights all light up but the fans do not spin. If I install the connector by not using the guide, the error message still appears but the fans will light and spin. Colors are wonderful as are the different patterns. I just wish one wasn't defective and I wasn't getting the boot error message. Update: I am about to uninstall these and return them. They have been nothing but trouble since putting them in my build. The PWM connector only has two wires, in the number one spot and the number four spot. My OEM fan has three wires going to each pin. Without that third wire I cannot get these to work correctly. I even purchased a 4-pin to 3-pin adapter to no avail. I found out today that they will light up and spin even if not connected to the motherboard! I will start looking for a true 3-pin RGB set of fans and send these back, especially since one of them doesn't work any way.

Prefect price

Have had zero issues with this product, it's not the nicest quality but its perfectly acceptable for this price. Good, easy installation basically just plug screw and be done. My only issue is the LED's have a very bright white when they're off, which is not a big issue but its noticeable. If you don't care how the tower looks while its off, then there's no better for your money than these.

Came with all screws needed and 4x zip ties and a double sided 3m stick for the controller to mount. Ds logo intake was labeled on guide and helped from playing the guessing game. Worked perfectly on first boot and has a lot of good light modes would recommend to anyone!

fast delivery, descent packaging, upon initial box opening looks like very nice quality fans & hub

Love the looks of these, a ton of color combos and options. I had problem with power adapter and week later they sent a new at my door step with bonus 2 leds strips that are super bright.. Easy to install and setp up handy remote, only problem I have with it is the proprietary connectors for fans and leds strips. Other then that great deal.

The bang-for-buck ratio is excellent. Sat with my girlfriend for a full 10 minutes just scrolling through all the different colours and effects. Obviously the fans are going to be audible, but the sound level is pretty reasonable especially given the price. Found some of the fan cables were just a bit short to reach the connector hub especially after cable management. Not the *most* powerful fans, but with only these 6 fans and a stock Intel cpu air cooler my 1080ti only reached 80 degrees under a brutal stress test and normally runs between 33-38 while overclocked a fair bit (granted with the gpu fans at 100%). Have the fan rgb to match the green and cyan of my desk setup.

These look great and work great! Just wish my motherboard could control them individually. The LEDs are bright and beautiful. The fans are relatively quiet and were easy to install. I was able to plug the controller on my motherboard allowing me to customize and control the lights just the way I wanted them!