Dongar Dashcam Integrator (10-pin Type B). Compatible with Select Toyota, Lexus, Subaru Models. Power Adapter Connects to Rearview Mirror, Built-in USB-C

I was really hesitant about this, but I went ahead and took the plunge. I have a 2025 RX 350h that this is installed in. The install was very easy. The hardest part was getting the plastic covers on/off the rearview mirror. There's not a ton of room behind the mirror. The Lexus cover clips are also an issue when you're trying to reassemble anything. Definitely find a Lexus install video because there are some tricky parts. I have a REDTIGER 4K Dash Cam Front Rear, STARVIS 2 Sensor hooked up to it and there seems to be no issues with the car electronic or the dash cam. The power cord section is plenty long to reach most center window placements. The connector definitely fits the Lexus RX 350. I spent a lot of time trying to make sure this was the right connector for my car without have to pull all molding off to inspect the connector in the car. I would definitely buy this again and have recommended it to friends.

This item was very easy to install on a Sienna Minivan. This works exactly as intended and now I do not need to deal with a messy power adapter.

Works great. The rig is well-made and feels sufficiently sturdy. I appreciate the power indicator. I was a little nervous pulling up the plastic trim to get to the connectors, but once I was able to get in there (almost risking breaking the plastic clips! Be careful...) I had no problems with the installation. Be careful to not remove the Toyota Safety System connector. This is a rearview mirror power tap only! Consider placing a bedsheet over the dash for scratch protection in case you drop objects on it or unintentionally throw trim parts during removal. There are cheaper clones, but I didn't want to take any additional risks. Cars are expensive. I wanted to be sure this would fit and not damage any connectors because of poor tolerances, and this succeeds. The connectors fit well and insert with gentle force without putting any of the OEM parts at risk.

This worked on my 2021 Toyota Sienna XLE AWD with a Vantrue T3 dash cam. Everything I needed was inside the box. The install was quick and easy.

Wow!! I found this by mistake while looking for a way to wire my 2018 Land Cruiser with my VanTrue dashcam. I watched a few videos on YouTube and figured I would try it out. Its so easy to install with a little patience. Looks factory installed and works perfect. I have attached a few pics so you can see my install. Some of you guys with your wires everywhere make me laugh. I would also like to point out this will fit the 2016-2021 Land Cruiser and im not sure why the ad says it wont fit. Its a 10 pin so it works perfect. Don't get the cheap one, spend the extra money and get this one.

I can confirm this model works with the Toyota Highlander Hybrid 2017 Limited Platinum!

This thing is a game changer. Installation was super easy. This is so much easier than having to use a fuse tap and tuck the wire from the fuse box to the dash cam.

I had to replace my battery in a new car with 30 days old. Dealer pointed out this harness caused parasitic drain.

Make sure you get the correct Dongar for your vehicle - then it is al so simple, quick and tidy. Great Device!! Totally removes the hassle of feeding wires from the camera to some remote power source.

Super easy to install, works like a charm

Just installed it on my 2022 Lexus RX 350 and it works perfectly! The installation took me like 10 minutes!

As it says, much simpler alternative to powering a dashcam than hardworking to the cabin fusebox. I'm not sure it can run 2, so i just have the front installed. Word of warning, don't connect anything to the car's ADAS sensors, like the front camera. Leave that alone. Self dimming mirrors are fine.

Dongar is a very good product