Thermal Grizzly - PhaseSheet PTM (50x40mm)- High Performance Thermal pad with Phase Change Material | Durable, not electrically Conductive | for CPU, GPU & Electronics Cooling

Incredibly difficult application, following all instructions including putting in freezer did not help, thermal pad was stuck to the plastic and was ruined by the time I got it out, stick with paste, this is not worth the hassle, I can get a regular paste application done in under a minute, but this took me an hour and still failed horribly.

Came in nice, neat packaging. Works very well.

I own a Lambda Tensorbook 2 (basically a Razer 15) for a few years now. Some days ago, I opened it up, and re applied thermal paste (MX-40) carefully on GPU and CPU. The improvement was significant, but it showed two hotter spots which were still causing some throttling. So I decided to try this product. I left it in the fridge about 10 minutes, cleaned the old paste, cut the sheet into two pieces for GPU and CPU, and applied the sheets over them. BOOM. 5 seconds. The peel is a bit hard to remove, technical tweezers helped. I cut it slightly bigger than the chips, and still got some left for a change in the future. TEMPS ARE INSANE! The PC sits now at 4300 MHz across all cores in PL2 (boost mode) with avg temp around 80 (more or less 20 seconds boost, 90 W), and at 3700 all cores in PL2 at about 60 degrees. ZERO THERMAL THROTTLING. The GPU couldn’t get hotter than 61 degrees in 5 minutes of test load. My fans are now basically never on. I am very happy with the purchase.

Todo perfecto, fácil aplicación y las temperaturas del portátil han bajado considerable.

Excellent getting 30c to 70c on hotspot watting for inbeding on a rx9060tx gpu 30c to 45c have got a few heat sinks an the back plate thou.

Excellent cooling. CPU maintained at 38C at idle versus 46C with cryosheet which found has uneven clamping when replacing to phaseshift.