AT10II 12 Channels RC Transmitter and Receiver R12DS 2.4GHz Radio Remote, Voltage Telemetry for RC Airplane, FPV Racing Drone, Quad, Helicopter, Car and Boat (Mode 2 Left-Hand Throttle)

This Transmitter Receiver combo is hard to beat. The reception is great as tested against spektrum at ground level and it worked great flew my helicopter up until i could'nt see it and and still had full reception bars on the transmitter . you get signal strenght, receiver battery voltage and flight pack voltage all on screen during flight.... The gimbals are far smoother than my spektrum ix12 and dx8 g2. its setup is easy and has a lot of functions for planes, multirotor and helicopters, etc. i would recommend it if you are looking for something that is economical and will out perform other transmitters in its class.it will be great for fpv with 3ms response time. buy it and see you wont be disappointed.

I used it for the first time today and so far couldn't be happier. Easy to bind, I set it up on my PA18 Cub with flaps. Set up 2 of the switches for my needs, again easy to figure out without the manual. Went to the flying field today and flew the Cub several times without a hitch. The response is excellent, I used the 12 channel receiver it came with. Today I ordered 2 10 channel receivers. I believe for the money you can't beat the price, and with receivers starting at $19.99! I have been flying a high end Graupner for a number of years, but with them no longer in the US, possibly for good, I wanted to test out another system. I am impressed so far and plane to go back out tomorrow for further testing. So yea, I would definitely recommend this transmitter. 1. ease of use. 2. low cost, 3. functionality and great feel.

I bought this one with additional R12DS just like to check it out how good it is, have not decided which model will be used with this new toy. I own three JR and one Futaba radios, their quality is no doubt for serious model builders. This AT10II which is only 1/7 price of one of my JR radios, I have to say I was surprised of this 11 channel product in such low price, I checked its timing waveform with scope then connected with five JR4131 high speed servos which consume high current to see its stability at least on the bench, it works and did not interfere each other. My concern is its battery connector, two-pin header without latch or locking, what happen is battery bay pop out then battery will fall out! It should use typical 9.6V NiMH RC battery connector which is three-pin also preventing to reverse the pin by mistake. I won't use LiPO type here, connector is different and higher risk for radio. The overall build quality is okay, I hope it will last many years to come. The user's manual is a big problem, not cover the basic at all, user has to try to find it out, sure there is room for them to improve it. One thing I like it is able to do two-way communication, radio can display the receiver status, that's really cool. I think I will use it with a glider first, stay tuned.

Very good Rc Transmiter and reciver. It works fine.

The instructions are terrible. Literally useless. This appears to be a foreign maker who poorly translated instructions from their native language. There are no videos online on how to set it up. Any online instructions are just PDFS of the useless manual in the box. The menus on the device itself are not intuitive and there is no explanation on what the different sub menus are for or under what circumstances variables need to be changed. Save yourself the headache and hours of wasted time trying to figure it out yourself and buy a different brand.

The Radiolink AT10II 12CH RC Transmitter and Receiver R12DS 2.4GHz DSSS & FHSS package deal is a real good value. When the Radio first arrived at my home I started to return the unit when I realized the transmitter would not bind with my store bought ready made Drones with existing receivers in them. Then after researching online I decided to replace all the Avionics in one of my big Orion drones. New Flight Controller, GPS, F.P.V., obstacle avoidance, full Telemetry and follow me. I will use the existing motors with the large Orion Air frame and the with 2200 mah Lipo battery. I think this radio with its R12DS receiver will do a good with this project. Thank for a good honest product. I will probably use the Radiolink Flight Controller in this project. Still doing research online. Dragoni

This radio is okay. I bought it after reading the great reviews. I am new to the RC flying world so I didn't have much to go on. However, I quickly learned some things: * There is open-source radio software called openTX, and it's amazing. It has tons of mixing options, voice prompts, and a nice user interface. It supports multiple receiver brands. * This radio does not run openTX. Its software is easy to use but pretty limited in comparison. It has limited mixing (4 linear channels and 2 curves) and the interface isn't particularly pleasing to look at. It works only with RadioLink receivers. * This radio is easy to bind to the receiver (and comes bound to the included receiver). The telemetry works great and the connection survives at really close range (like a few inches from the model), which is great for controlling an indoor vehicle. Other setups sometimes have trouble at close range. * The build quality is just okay. The plastic finish feels somewhat cheap (the texture isn't great) and the menu wheel and buttons are not fun to use. They feel really hard and plasticky. I had issues with the little joystick and wheel setup; as I would spin the wheel my thumb would hit the joystick and I would end up adjusting a nearby setting to the one I wanted. * The battery bay is too small to fit dual 18650 cells (a typical 7.4 pack) so you will need to use AAs with the included 8x AA holder or find a small rechargeable battery. There is no foam in the battery bay so you might need to add some to prevent your battery from flopping around. * My radio arrived with a defective AA holder; it was missing a contact. Support was super friendly and responsive and sent me a replacement. For this price, I strongly recommend that you consider an openTX-capable radio. For examples, look at RadioMaster, Jumper, and FrSky. I ended up getting a RadioMaster TX16s and it blows this radio away in every category for a few dollars more.

For beginners,((could be a little over wellming )they should start with basic 4channel radio.This 12channel radio system has a lot of feature that need to be programmed with understanding of avionics to do amazing things. The price is hard to beat, with so many features to amaze a diehard R/C Pilot. I've owned all Futaba Radios for more than 40+yrs. and to buy a 12 ch.Futaba system is out of my price range. I haven't yet decided what I'm useing this 12ch.radio on. It's built well, I would RECOMEND this full featured radio system to any R/C Pilot !

Muy buena ràdio y muy buen precio,la relación calidad precio es excelente,llegó antes de lo estipulado estoy muy contento y está gente de amazon son muy serios alguna vez he tenido algún problema y siempre me han atendido y solucionado todo en fin todo good

gebruik hem nu al een tijdje ik heb er totaal geen problemen mee

Es muy buen producto para comenzar, y tiene buen alcance. Las palancas se sienten bien, solo tal vez no tengan la mejor precisión pero cumplen muy bien! Lo ocupo para volar drones

easy to set up and use - nothing negative so far

Émetteur et récepteur très bon. Au ciné perte de signal utilisé sur hélicoptère. Très bon rapport qualité prix