Hoypeyfiy Carburetor Kit Replacement for Makita BHX2500 BHX2500V BHX2500CA PB2504 24.5cc Leaf Blower, Replace 168641-9 592-60220-01 592-60220-00, with Gasket and Fuel Line

used to replace the carb on my Dolmar{makita} ms251 trimmer as I could not find a replacement carb anywhere , had to rotate the linkage mechanism by removing two screws and rotating it 180 degrees, added the new fuel lines, cut the plastic housing slightly to accommodate the carb mounted primer bulb, primed the carb and it started on the 3rd pull, works perfectly....

I have the BHX2500”CA” model blower. The “CA” means that it meets California emissions standards. Those standards require that the factory carb be set for optimum emissions, not optimum performance. And they also require that the carb cannot be adjusted by the consumer, so as soon as some wear occurs or some deposits build up the blower starts to run poorly and, except for cleaning/rebuilding that factory carb there is nothing you can do. And even if you fix it, it will just happen again. I do like clean air, but in this case the specifications have a negative effect on the reliability and durability of the machine. The solution is to get an aftermarket carb that is adjustable, like this one. The new carb was easy to mount and connect. The blower started right up and with a few adjustments my blower now runs stronger than when it was new. NOTE: This comes with a new fuel supply/return/filter hose assembly that mounts on top of the fuel tank with a rubber grommet. The new grommet has a different design than the factory grommet. Due to the thickness of the fuel tank material I was unable to install the new grommet and ended up reusing the original grommet with the new hoses and filter.

Great product! It fits Makita BHX2500 that I have replaced My blower with new parts and gasoline plastic pumper are back on action. Thanks

Looks well made, but will not take throttle above idle. Tried adjusting air / fuel mixture, still will not take throttle. Old carb works fine, just needs new primer bulb, will see about just new primer bulb. Returned carb.

My blower was bogging down when I would run it at full speed. I replaced the air filter and spark plug but the machine did not run any better. A little research led me to replace the carburetor. I used the original gasket as it was still clean and much larger than the one sent with the new unit. I was forced to use the old gas lines and fuel filter as the ones supplied with were a bit too short. Unit is working great now. A relatively easy and inexpensive fix!

Excelente

A good buy for an exact replacement. Easy installation. I could buy the entire carb for a few dollars more than the connector I needed to replace.

The carb is OK. Wrong material being used for fuel line. It swells and disintegrated after coming contact with gasoline. I reused the old fuel line.

J’ai souffleur de feuilles qui ne fonctionne pas bien depuis certain temps. J’ai décidé changer carburateur de Makita BHX2500CA Ca fonctionne très bien en remplaçant le carburateur.

This carburettor fixed my Makita it now runs great 👍 fairly easy to install.

Bien

Works great