SPST 2 Pins 2 Position ON/Off Car Boat Black Rocker Switch

This stitch was a direct replacement for the one on my shop drill press and got it quickly back into operation. Did not really need 5 switches, but the price made it worth buying the extras, which subsequently came in handy for another job. The original switch was over 30 years old, so we will see how this holds up

I bought this switch after buying identically looking switches on AliExpress and finding out that they had "ON" resistance of 1-4 Ohm (!) - absolutely useless for the 10A ratings. When I received switches from Amazon, I immediately checked the "ON" resistance and it was less than 50 milliohms, so the quality was very reasonable. The switch has a bidirectional LED with current limiting resistor, not a neon bulb, so it is usable from approximately 30V to 240V, AC or DC of any polarity. It is enough bright at 120V AC. The only disadvantage - I wanted to replace the switch in older US-made power extender, and the width of this switch is less than the old one by ~2mm.

Great switch works great but as I said had to redo switch slot as new switch was skinnier

Works great! Changed out bad switches on electric fireplace. Fast shipping. Highly Recommend!

They fit my control panel. But the color is a bit off when lite.

OK to use

Works perfectly!

The switch on my Air Compressor stopped working , these fixed it. I did have to enlarge the original hole for these to fit, but it fixed my problem

Très satisfait

the toggle switch on our meat slicer went bad so we replaced it with this product, it cost a lot less than having to buy a new slicer !!

I bought these blue LED rocker switches for an RV project. I added a switch inside my RV on the "Convenience Center" to control on/off of my hot water tank electric element. For some reason many RVs only come from factory with a switch outside behind the outer access panel. When trying to manage 30 amp RV power usage, you can only run two major appliances simultaneously, the hot water tank being one of those. So if trying to heat water, make toast, make coffee, use microwave, you can only pick 2 of those at a time. When wanting to keep heating hot water you need to turn that element on and off periodically as you use other appliances, so having the switch only outside the trailer is a pain in the butt. Adding a switch inside the trailer makes this a simple process now. The power draw of the RV water heater element is 12 amps at 120 volts, and this switch is rated for 20 amps at 120V, so it should handle this load with no problems. I installed this switch in the "Convenience Center" and used high temp (200°C) 600V AC rated 14 gauge wiring (minimum 120°C wire recommended by RV manufacturer) and 90° & Straight spade terminals (also bought on Amazon) for connections. Install went perfectly. I followed typical wiring for these toggles, with "power in" connecting to outer silver terminal, "power out" connecting to middle silver terminal, and white/neutral wire connecting to outer brass terminal (for LED light). You can use the rocker switch without the neutral wire but the LED will not light. If you want the LED to light when switched on you must connect a neutral (AC) line from the brass terminal to a neutral line or back to the neutral bus bar in your circuit breaker panel. After install I activated power to water heater element for about an hour before it reached shut-off temperature. During this time I checked temp on the toggle switch and after the hour I could feel a very slight bit of warmth, but just barely discernible, so at this point am happily not experiencing the melt-down temps some reviewers have reported. The switch has a nice positive "click" to it, terminals feel solid and LED light is nice and bright when switched "on". Attached photos show the rear connections prior to install, and then the switch in place both "off" (unlit), and "on" (illuminated). I installed the rocker switch in an unused removable filler plug on my panel that I cut a hole in to fit the press-in switch. At this point I'm very happy with this switch and highly recommend it. Not many sellers offer these blue coloured switches (typical in RVs) rated for AC power so I was happy to find these. If my opinion changes after extended use I'll be sure to update this review, but after initial install and use all seems good so far.

Very nice little switches. Wan't familiar with the wiring but lots of help online. Green light is visible in daylight but not too bright at night. Added 3 switches. to the dash in the van.

In my brother's trailer, he had not had hot water working for two years. He just never figured out what was wrong, so after taking a weekend to pull everything apart, he found the similar switch had shorted out (it was way in and under a cabinet, not easy to get to at all!). This replacement works perfectly, is rated exactly the same and he also has 4 spares. All for a fraction of the price of one from the place he bought the trailer from!