45 x 52 mm Red Perforated Shrink Band for Hot Sauce, Woozy, Drip & Liquid Bottles [Cap Diameter: 1"] Pack of 250

These bottles boast good quality and size.

The product worked as promised on my hot sauce bottle caps. The quality of the shrink was smooth and fast. Use of a heat gun is important for best results.

Quality solution for securing the bottle tops

They are pretty good. I get an occasional few that get large holes in them and have to discard them and use another to replace them.

Could not be any easier to use, and only takes a few seconds with a regular hair dryer. Great fun way to get the kids involved in a small family business. Getting ready to order more!!!

They work OK but are as not as good as others that I have purchased in the past. The style that covers the lid of the bottle costs a bit more but is worth the cost.

We make our own sauces and these are amazing.

They do the trick but are a little smaller in height than I'd prefer. I can't knock the rating though, I now know I need a larger size.

Muy bueno

Arrived in good time, easy to apply and look great a very professional finish

The heat-shrink wrappers are only 0.05mm thick and this can present some challenges with obtaining a nice, consistent shrink on your bottles. That being said, they are quite nice in appearance and I would still recommend these. Allow me to share some of my experiences and some suggestions. 1. Shrink these on room-temperature bottles - do not try them on cold ones. The first couple of tries resulted in less than ideal results because I was trying to shrink these on bottles which were refrigerated. I got inconsistent results until I pre-warmed the necks with my heat gun. 2. Keep your heat-source moving at all times; the objective is consistent heat application. Keep the heat gun a steady distance from the bottles while you work. 3. Fully open the heat-shrinks when putting them on the bottle neck and ideally, start the shrinking process on the folds to help them relax and flatten fully. I found that this gave me the straightest perforated rip-line. 4. A rotary table (ideally motorized) would greatly help with even heating 5. Be patient. Start with your heat gun further away then you think and gradually move closer until you start to see some shrinkage. Keeping the heat further away will help with more uniform heating and also prevents too much heat being applied in one area in a short time Un-tested: If you have access to a steam-wand, it may be an ideal method to apply these; I plan to try mine on the next batch.

I would buy these shrink wraps again for bottling for sure! Great product.

Leider nicht wie vorgesehen funktioniert, deswegen ist es wieder zurück gegangen