FEL-PRO MS 92270-4 Engine Intake Manifold Gasket Set for Nissan Xterra

All I can really say is that the gasket set looked to be decent quality, and was packaged well. I got this because it was one of the parts listed for replacement by the mechanic, after an automotive inspection to fix a check engine light. It turns out he listed it because he had planned on removing the top of the engine manifold to more easily access the #6 spark plug in my 2004 Nissan Xterra. I guess once removed, the gaskets should be replaced, and that is why he had it on the inspection list. A friend and I ended up replacing the plugs ourself without removing the manifold, so I ended up not needing the gaskets and returned them unopened without issue. The #6 plug is a pain to replace due to its location and would have been easier with the manifold removed, so depending if you have the right tools, someone with small hands, and don't get irritated easily you can do it without getting this set of gaskets, but if you don't mind a few extra steps to make plug installation easier, then these gaskets seemed like they would have been the correct size, decent quality, and well priced.

Fit like should

It's a gasket. No complaints.

Bueno producto

Successfully installed on a '93 Pathfinder (VG30E). I first attempted to install a Victor-Reinz set that was slightly cheaper and was made of very thin stamped steel. This lowered the intake enough that nothing lined up or sealed properly. I had to tear the thing back apart, chuck that leaky garbage, and install these. The timing cover, EGR, and intake ports all line up properly, they've got some rubber to them so the pitting on the heads wasn't an issue, and the motor runs great. Would buy again.

This was an exact fit for a 2004 xterra 3.3 vg33e engine. Seemed to be higher quality than oem. Still used copper seal on both sides to make sure I don’t develop any leaks down the road.

I’m a spend-conscious diy mechanic. I’ve previously experimented with the cheaper gasket sets. There is no comparison to the quality of the fuel pro gaskets. These are thick, rubbery, and “tacky.” Additionally, they are labeled. I hesitated, because of price, but the quality is top- notch. Don’t use knock off materials for heads/ intakes/ critical areas; imo. Fits Vg33e 3.3

Correct gasket that I needed