Muzata 20Pack 1/8" Swage Lag Screws Left & Right Cable Railing Hardware Kit Handed Thread for Wood Post T316 Stainless Steel Stair Deck WoodBudget System 10 Pairs CK17

Items as described and delivered quickly. They have finished off the stair balustrade perfectly and look really modern. The clips do need alot of pressure to crimp the wire in place so make sure you have some strong crimpers!

I was a bit dubious as they were a lot cheaper than the alternatives but... Surprisingly good. Easy install for a DIY and really effective

Good stuff. You’ll need a good crimping tool, but al good

This is a small scale system and needs expertise to fit well. Not for the novice at any scale. Ingenious idea though. I wouldn’t use it again.

First time using this system, I’m very impressed on how easy, quick and clean these look when installed. A little more time consuming than other options but well worth the effort.

Happy with this product. Easy to use and looks excellent. I will order more for another deck.

Strong and easy to install. Used to replace glass that were causing bird strikes. Quick set up and simple instructions allowed for a fantastic looking deck that doesn't need painting or staining in the same manner as spindles. I have purchased more since the initial install to complete my other deck.

Screws were easy to install, and they look fantastic. It’s been about 6 months and they’re still holding up great

Fantastic value and build. After watching a few Youtube install vids, I found these to be fairly straightforward. I crimped with bolt-cutters and IMO, the look is great. Sure, a flatter crimp may look better but who's inspecting at that level. These sleeves are pretty thin and streamlined. And for the record, a bolt cutter crimp will hold! I miss-measured my 1st cable and thought maybe I could hammer out the crimp. No way! I tried everything and that cable was not coming out. Since I had limited cable, I wound up taking a Dremel with a cutting disc and dissecting the sleeve to get the cable out. These things are bullet proof. Next time I'll just have extra cable! Anyway ... the only thing I wish the manufacturer supplied (besides wrench) would be a chart for how to measure cable length based on span & stretch. It was a bit of trial and error but I nailed it on the 2nd one. For a 12ft span, I trimmed my cable by 1.25". That allowed my screws so penetrate the post with zero thread showing and piano-string tight. Lastly, one YouTuber had a great tip. If you have 7 runs of cable to do. Do every other one first so you'll have more room to tighten the bolts without hitting the run above and below. And most importantly, pre-drill the holes with your swage screws mounted in the drill. Run it in and out a few times so the tensioning process is smoother! You'll be happy you did.

Assez facile à utiliser, mais pas évident de couper la bonne longueur de fil… si on fait une erreur, les vis tire-fond sont à jeter! La finition n’est pas super soignée car il faut écraser les vis pour coincer les fils. Parfois, elles crochissent. Je recommande tout de même.

Works great and looks good