EKSAVE 12V LED Strip Light, SMD 5630 Flexible,Waterproof,16.4ft Tape Light for Home, Kitchen and More,White 6000K(No Power Adapter)

Excellent even Lumen output and color temperature for getting a head start on seedlings for the season. Also perfect the fact they are 12 volts and I could put the line voltage supply out of proximity in case of a spill. 3 rows of 22 inches each provides perfect bright illumination per tier for growth of herbs and vegetables compared to thin single overly bright grow strips usually sold, where close plants burn and shade lumens from the rest. Had no problems with adhesion onto PVC board. Just make sure you clean the surface well with rubbing alcohol or Windex and allow to dry. Time will tell longevity as they run 12 hours a day in 70°.

Led strip lights are bright. The water proof rubber can be peeled and cut if not wanting to have it on. Only positive thing I can say about this purchase.What's negative. Adhesive stickiness is useless. Will need more support.Been trying out multiple types of connectors. If your going to plan on cutting and using connectors for other lengths, then stay away from purchasing this. It's impossible so far. More frustrating.I did reach out to the seller. Took over a week before receiving a response. What was suggested, already tried. Plus connector suggested, had actually said my led lights are not compatible. Like seriously. So I'm buying from another seller now.

Wrapped the entire roll around a 3" diameter piece of PVC, whole thing lights up, but it isn't quite what I am use to for the brightness of 5630s.

The media could not be loaded. Very bright , I liked that you could cut to length , you can either have one long strip or several strips, Adhesion will be determined in time - I used RTV silicone as a backup since it is in the bed of my truck (under Tonneau cover) so it will be shielded from Elements .. Already have projects in Mind !

very bright only issue the adhesion is terrible. order some 3m double sided tape to use to hold the lights up

After just one week of using these strips, I have had multiple clusters go out in my strip, as you can see in my pictures. They were fantastic when first installed. Now I'm totally screwed, I can't take the product down and send it back as it has been installed and the strip has been cut (at the designated cut point.) I went through a lot of trouble to do a nice install on these and I'm totally disappointed that they are garbage, you could tell just by looking at the strip it may be poor quality. The SMDs are all crooked and not aligned properly, some of them look as if they are barely soldered to the PCB. I hope the seller reaches out to resolve this in some way

Very bright, almost blue white. Adhesion didn’t hold though on the surface I was trying to stick it to. Had to use VHB tape to keep them stuck on.

The product did not come with a female dc wire like described in both the image and description. Instead all it had was two wires at both ends of the strip. I tried making a make shift battery source to connect it to but that didn't work very well.