TOYOTA Genuine (89422-33030) Water Temperature Sensor

Part arrived on time in good condition. Installation was easy. Part functioned as designed

Cien por ciento pieza genuina sólo ponga atención esta pieza debe traer grabado el número de pieza en el aluminio si no lo tiene no lo es genuina pila con eso

Few months and it hasn’t failed, will update review if it does.

good value and easy to install

Shipped quickly, poor packaging, missing copper washer for heat sensitivity and sealing to prevent leaking for some model vehicles. On Toyota it requires a small rubber washer to prevent leaking as the tubing it attaches to is a type of plastic. Leaking or lack of proper sealing can throw P2601 error as well as cause fuel air mixture errors. You will see a reduction in gas milage and the down line sensor can send our of range errors. Other related error codes P1115 and P1150 can result. Stamped with correct part number. Was going to return for lack of gasket. Found a gasket on hand and went forward with the install. So far the error codes have not reappeared after long drive for testing, engine up to full temp. This sensor is used by the vehicle to determine air fuel mixture by the computer. Using it not properly sealed with a rubber gasket can cause issues and the check engine light will appear. A reader may simply say stop driving immediately and you may need to run a more in-depth scan. The in -depth scan said it was an error P1150 bay 2 on the catalectic converter. The actual issue is that the coolant tank sensor that was installed didn't have any gasket and was leaking. To be clear the coolant heat tank pump is a new pump and was tested to ensure it was working as well. All wiring was also check. You should also check all of your coolant system lines for any other possible leaks as Toyota coolant systems are pressurized systems. The only leak found on this repair was at this heat pump sensor which was drawing air into the system due to not being sealed with a proper gasket. Your vehicle may be different. In this case, all of the pumps had been replace due to the age of the vehicle, the sensor was changed at the same time as preventative maintenance. The error codes start a few months later when the cold weather came. The purpose for sharing this information is in the hopes that it might be helpful to someone. Looking at the codes only was insufficient and there was no need for costly repairs.

Great quality and fast delivery. The product was just as described very satisfied with my purchase!

Came on time. Looks like oem.

Fixed an issue on our 2014 Sequoia with it cranking long starting rough in the winter!!

This is the right engine coolant temperature sensor for 2006 Toyota prius.

英語のレビューでOEMとありますが 届くのはセンサー部分に段付き加工有りトヨタ純正部品です

They sent original one, but it was produced 5 years ago and the package was opened condition. Also electric connector was dirty because someone touched. It was expensive than other country and condition was not good as I expected.

Perfectly fits Corolla 2009.

この水温センサー交換後、エンジン始動後に暫く緑の水温計が点灯する様になり、何か異常でもあるのか？それとも取り付け失敗したのか？と疑問を持ちネットで調べたところ、水温が51℃以上になると消えることが判明。ウォーターポンプ交換したついでに予備整備のつもりで交換したんですが、では今までエンジン始動直後に水温計が消えてたのは、水温センサーが仕事してなかったのか？と疑問を持っています 笑