08749 High Bond Rearview Mirror Adhesive - 0.02 fl. oz.

Perfect bond for rear view mirror mount for all type of cars. I purchased this product to fix the rear view mirror bracket of my Skoda Superb car. It bonds quickly and makes very strong bond in 1minute. All you need is, you should follow instructions clearly to get perfect results. It fails only if you didn't follow the instructions.. For me it works on the first attempt itself. Very good product from the manufacturer.. Thanks a lot.

It didn’t work for me.

It's been a hot summer and my mirrot fell off. The first time I tried this glue, I followed the instructions exactly. They say to spread the activator, wait a few minutes, and put a drop of glue on the button (and smoosh it around a bit against the windshield). This DID NOT WORK for me. The button fell off the next day (I waited 24 hours) when I tried to attach the mirror. I tried again with the rest of the activator (not much) left in the package, and all the glue left. This time I covered the button in glue. Once again I waited 24 hours. (The instructions didn't say to do this, but I figured I would just to be safe.) Attached the mirror with no problem and it's been a month now and it's going strong. Fingers crossed it continues like that!

لا يلصق

A week after using and my mirror is back in place and stable so far. Since it's a one use product I used far more glue than necessary and covered the surface of the mirror holder as I'd read from reviews that following the instructions of "one drop" usually resulted in failure.

It's a two-step process. 1. Apply the 'activator.' This is very runny stuff that's blue. You swab it on both surfaces then wait 5 minutes. 2. Apply the adhesive. This is thicker stuff that you apply only to mounting 'button' not the windshield. Hold down for a minute. The mounting button should stay stuck on. Wait about 15 minutes and slide your mirror on. Worked exactly as described for me. Just triple check that you're gluing the mounting 'button' on in the proper orientation. If you mess up you have to pull it off and that may not be easy. Also, if you have any trim pieces that hide wiring and such, make sure it's all in in place before you glue on the button as the mounting angles may be such that it's difficult after the fact. This happend to me. Luckily I was able to bend the plastic trim into place without it breaking after I had the mirror on. I needed this product because my mirror feel off on a very hot day after 23 years. If it happens again I would buy this product, assuming it stays stuck on for many years to come.