Platinum Tools 202016J EZ-RJ45 Cat 6 Connector and Strain Relief Combo Kit, 50-Pieces

Works well!

What's not to like? the feed through makes terminations fast and allows you to pre-inspect to avoid pair mismatches before crimping. So far I have not had to re-do any terminations. Great time and frustration saver.

facilita la instalación y evita la falla en el código de colores ahorro en el tiempo de armado y muy buena calidad

These products are the best. Not the cheapest but save time and 100 percent reliable. I make very few errors.

This is a review of the Platinum 202016J EX-RJ45 Cat 6 Connector and Strain Relief Combo Kit 50 Pieces. Crimper Used – While I am sure the oem crimper designed for these would be ideal, I used a typical set of RJ45 crimpers. My endings are rock solid and super tight. My cables have been hooked up to pc and router affirming 1gb/s connection. Summary – I have used numerous Ethernet connections in the past and these pass through type are making me wish I found them years ago. Instead of using the connectors in which it is hard to see if your cables stayed in the proper order during the crimp, these are pass through design and allow the cables to go straight through the end. This gives you 100% verification as to the proper order. Note – You can cut the extra wire over hang flush by using a set of clippers. (Clippers should be a type to allow for a very close cut so the wires do not overhang.) An alternative would be to Cut the cables passing through the connector flush with the end of the connector, then pull back the wires just enough so they do not clear the end of the adapter - are exposed and then do you your hard crimp. To prepare wires so they go right through the connector on the first time is very simple. Just strip back the jacket of your wire 1” to 2”, use a screwdriver shaft to pull the wires over to straighten and then use your thumb to “pull-press down” on the cables to get your final smoothness-order. Then use a wire cutter to cut the end flat to allow for easy entry into the connector. The strain reliefs to me are also perfect. The last ones I had were too tight for my cat6 cables. These fit all the various types of cables I would be using these for. They feel as though they are made of a hard plastic, yet the relief section of the clip still remains flexible when you move it. Fully assembled, it looks and performs great.