Uncle Mike's QD Quick Detachable Super Swivel 1391-2 for 1" slings , Black

Made in china, but very good quality. fits my marlin 44 mag perfectly. rigid.

Can’t beat Uncle Miks’s sling mounts for quality and price. You need a good sling on your weapon- and this is an easy diy job, folks…you can do this with a steady hand drill and good gunsmiths torque driver set. Hint- hold the magazine clamp tightly (I use a small brass clamp over the barrel) and just snug the screw closest to the mag, then tighten the “jack” screw to the spec in the instructions that come with the set. And put a little wood glue on the threads of the stock mount- it’s not supposed to ever come out. After the glue dries, seal the wood finish around the drilled hole with wood floor wax.

Easy to install and fit perfectly. Look good in place and are secure to gun and sling.

Product fit my Marlin 336 (in 35 Rem) nicely. The split clamshell design fit the mag tube very well and is much more preferable than drilling a hole in the forearm or disassembling the barrel/mag tube to slide something in there. Installation instructions were clear with pictures and easy to follow. The only thing keeping this from a 5 star review is the poor quality of the hardware to affix the front clamp. The small allen screw in particular is one of those single-use type of screws as if you try to tighten it or remove it more than once it quickly strips the head. So be careful and gentle and using some loctite on the screw threads is a good idea as you can't torque this small screw much at all or you'll strip it out quickly. The product is made in China so getting sub-par hardware isn't a shock, even though the rest of the product is well made and precise fitting.

Great

My magazine tube was .640 Fit was good. Came with instructions.

Works grat on the winchester 94. Easy to install, very sturdy, good quality.

This particular Uncle Mike's sling mount kit is the easiest way to add a sling to the Hatsan Striker 1000 (x or s), even the Edge. All have the same barreled action. I measured the .22 caliber version's barrel @ .628". The ID of this kit's barrel clamp is .630". Perfect size to make short work of Hatsan's short-sightedness. You just need to drill a hole the same as the pitch diameter of the sling mount screw 2 1/2" in from the edge of the lower butt stock and you're good to go! The Striker 1000x's barreled action seen here being custom mounted in a Hatsan model 95 stock being chopped and fitted to the 1000x action. The clamp would need to move forward 1/4" on the factory 1000x stock. Fit and finish match the finish on the rifle very well indeed! I highly recommend this kit for all you tinkers out there!

solide

These fit my Henry 44 mag and 30/30 also my 35 rem.

Fits Perfect. Exactly what I was looking for.

Seems to be good, will see when I use them

Allen screw is made of very soft metal. Be very careful when tightening as screw will strip. Otherwise excellent product for the Mossberg 464.