Original Creality CR6 SE Hotend Extruder Full Kit Assembled for CR-6 SE CR6 MAX 3D Printer w/Auto Leveling, Back Support Bracket, Heater, Thermistor, Cooling System

Fitted perfectly easy to put on.10 min job

easy to install in my 3D Printer.

Replaced the entire unit and ran a 47 hour print flawlessly!!

Straight plug and play swap. Perfect layers immediately after.

Originally purchased this as my old one that came with the CR6SE stopped working after 2 years. Installed it and went to re-level the bed, strain gauge would not detect bed, tried different things and no luck, opened it up only to find the tiny adjuster screw was not on the circuit board. Returned it as a defect. Ordered another one and the same issue the strain gauge was not detecting the bed, the blue led indicator light did not come on and the head would go all the way into the bed before i shut the printer off. I checked the z stop and unplugged it and re-plugged it back it. Switched on the printer and the head instead of going down towards the bed was not going up and up. So i returned the part as defective. I'm still looking around the market for a replacement head, avoiding non-creality clones as these appear to be problematic.

Heat block so bent it’s pressed against the outer fan casing/shroud parts cooling fan mounts snapped due to been over tightened so wobbles about and as for the Bowden tube connector it can’t hold its self in place never mind a Bowden tube I’m sorry but for what I just paid it’s a joke and belongs in the bin not even going to attempt to put this on my printer