E-cowlboy For Harley-Davidson Twin Cam &Dyna tools Twin Cam Mainshaft Sprocket Socket Tool 2 1/4"(Fits: Dyna)

Works well and the price is unbeatable. The nut on my Dyna was very tight so I had to hammer it with a big impact to get it off and the socket held out just fine.

Worked exactly as it should. Seems to be a good quality and did the job I needed it to do. Would recommend

Just like the harley tool, works great, alot cheaper

Excellent socket. Saved me $$$ over the $200+ alternative. Paid for its self on the first use.

got the job done and is exactly what i needed. worth every penny!

Did the job tight fit on the nut as needed. Guide and thread protector is a great touch. Socket not super hardened in square drive that left some deformation and would likely be a problem if doing these nuts repeatedly but otherwise great value to get the job done

What I was needing

its rare that you would use it often as a do it yourself mechanic. But. when you need it. well well well it makes life easier. Used it a few times chasing transmission leaks only to find out the vent tube was clogged. Now, it sits and waits as part of my specialty tools just incase I need to use this socket again. well worth it.

Works A1 on a Shovelhead 4 speed transmission ; even the round ''donut'' adaptor has the right thread. Bought in july '25.

I used my impact on it to remove the nut and it held up no problem. Now the bushing guide that screws onto the end of the shaft didn't go on. They did not cut the threads the same. But it is only made of soft material ( Aluminum i think) so you can start to thread it on then force it on a little at a time. Just turn it till it's really tight then back it off and then turn it till you can't again and back it off and eventually your spline threads will cut new threads into the bushing guide. Just make sure you put some oil on the threads before you start and keep adding a little oil while your doing it. This is not the ideal way of doing it, if you have the proper tap size is the right way but this will work. If you don't get to far carried away by doing it this way you will be fine. The shaft is made of alot harder steel then the bushing so you shouldn't damage the threads on the spline.

10/10

bought for my bike and was 1/4 the price of the ones at clare’s and works exactly the same. don’t doubt amazon parts and tools.

Fantastic !!