Nilight Headlight Assembly for 2012 2013 2014 Toyota Camry L/LE/XLE/Hybrid LE XLE Headlamps Replacement Black Housing Amber Reflector Driver and Passenger Side, 2 Years Warranty

I loved it because it's super bright, the lights apart were perfect for my car, super good product

Looks great. I’m a 30 year collision repair technician and installed these on my personal vehicle. The headlights fit great, But the adjustments could use a little more attention. These headlights really could use a side to side an adjustment which most newer vehicles nowadays do not have.

I have no complaints! Showed on time and well packaged. I see that some people needed to remove the whole bumper but i only removed the top half and was able to remove the old and install the new ones. Everything lined up well and i did them one at a time in case i needed to use the other side has a reference point. Only thing that the packages said was that these light were already adjusted to the proper height from factory. I will need to disagree on this. I had to adjust both side by a lot, Driver side was aiming at the trees. CLOCKWISE = down, COUNTER CLOCKWISE = up. You will need a 10MM (because its a lot easier) to adjust light height. 20ft-25ft away from a wall, find center mark on the headlight assembly (small dot visible on light assembly, this is your center point. ) for my vehicle it was 28inches from floor once installed. You would transfer measurement on a wall and then back up the vehicle 20ft-25ft, your headlight line would need to be 2inch lower on passenger side and 3-4 inch lower on driver side. When i say lower i mean lower than the 28 inch mark on the wall. This will give you proper lighting height and not blind oncoming drivers, make sure you are on a level surface. Other note, where the low beam bulb plugs into, the cut out was a bit rough but not completely bad. It would screw on a bit loose for my liking so i use some rubber o-rings i had laying around to make the fitment more snug. .

Very easy install, perfect fit into the fender bolted right up to the Camry frame and it looks amazing. It’ll refresh a 2012 Camry instantly.

(2014 Camry Headlight assembly). It has terrible beam patterns and has black spots . Original H11 bulb fits loose. I used after market led bulb. LED H11 bulb had good beam pattern in original headlights assembly but not in this one that means low beam projector is not good. However, light output is supper clear👍