Clear Ice Ball Maker for Whiskey: FDDBI Circle Ice Cube Tray Make 2Inch Ice Sphere - Clear Ice Cube Maker for Old Fashioned Bourbon Whisky

This works! In our freezer it needs 3 days to set, then a minute in the microwave to release the cubes without tearing the mould. They are so large that they only initially fit in some of our tumblers!

Works well - freezes from the top down is how it’ creates clear ice cubes - best if you leave for 36? Hours in freezer. You can transfer into a zip lock bag to build up some stock of cubes

The ice cubes are massive and for whisky in large tumblers last for 2 to 3 hours, at ambient temp. Just chill your bottle first. A delightful and too delicious a solution. Chill out

First go n 97% crystal clear, cant moan at that 😊 shame they didnt do a 3’’ ball ad 2’’ is to small, More freezing to perfect the perfect ball 😊

Ice cubes are not entirely clear, but pretty close. Size wise, more like 2.5x1.25 inches rather than 2x2 inches and they have a small extrusion where the hole for the water to drain to the lower level is positioned. Would have been nice to get the correct instructions as opposed to those for a spherical ice maker.

Does exactly as it says. Foam outside does get pushed out when freezing from the ice but the final results are unreal. Follow the instructions and wait the time. Ended up buying 9 for all my shareholders.

As advertised. I've done one batch so far and I am very happy! It was a little bit tricky understand how to remove the silicone form because I did not want to break anything by pulling in the wrong direction. I let it stay for 5-10minutes and then I could lift the plastic tray up that contained the silicon tray. Basically it is only attached to the ice below the tray by the small piece of ice in the hole beneath the ice cubes. I took mine out after ~30h and they were mostly clear! There were some bubbles trapped and I might have cause scratches on some, but they should look very nice in a glass with something to drink. It was just one cube in the middle that for some reason rose above the others and got cloudy at the top, could have been med handling the tray getting into the fridge. The bottom tray ice didn't look to bad either but it wasn't fully frozen when I picked it up, potentially if it stays longer it could be used for some fun sculpting, or just hack it up in smaller pieces. I choose this clear ice maker because of the lid. I noticed that other open silicon molds picked up a scent from the fridge after a while, and that transferred to the cubes. This was helped by putting the silicon molds in the oven at 120C for a while but the cover should help with not getting the smell in the first place. Took some three weeks to get to Sweden. For the price this is perfect, I am very happy!

This tray works as-advertised. Super easy! I finally stopped using the old igloo cooler and mallet. Consistently good clear cubes. Follow the directions and dial in the perfect time to pull them out of the freezer and you’ll be happy. Since my purchase date, the plastic tray cracked in a couple of places. I reached out and the replaced it immediately! I was just hoping to buy the part. GREAT SERVICE!

Description says it takes 24-30 hours, the box says 36-48 hours. It's taken minimum 48 hours so far. If you pull it out before it's frozen you've wasted 2 whole days. Some instructions would have been helpful as I'm just guessing as I go along which is annoying. I am yet to get a batch of perfect ice, however the space that should have the cloudy excess has some very clear ice which with an ice pick would be great to use.

Simply put, the ice is not clear!